Tripp Lite 230/400 - Manuals

Page 2 - Important Safety Warnings; UPS Location Warnings; UPS Connection Warnings

2 Important Safety Warnings SAVE THESE INSTRUCTIONS. This manual contains important instructions and warnings that should be followed during the installation andmaintenance of all Tripp Lite SmartOnline 3-Phase 20kVA and 30kVA UPS Systems and their batteries. UPS Location Warnings • Install your UPS...

Page 3 - Control Panel; FRONT PANEL

1 2 3 4 13 12 7 10 11 9 8 5 6 3 Control Panel There are two separate UPS system modules: a power module and a battery module. Familiarize yourself with the location and function ofthe features on each module before installing and operating your UPS system. The power module is the only module which i...

Page 4 - Rear Panels

4 Rear Panels 1. Manual Bypass Switch: This dial is used in one step of putting the UPS in "BYPASS” mode, which must be done before performing any maintenance on the UPS with the connected load supported. [See “Operation (Special Conditions)” for step-by-step instructions forgoing into “BYPASS.”...

Page 6 - Installation; UPS LOCATION; UPS BATTERY MODULE HARDWIRE CONNECTION

6 Installation UPS LOCATION Move your UPS over short distances using its wheels. Stabilize the UPS by releasing the stabilizers on each side of the unit. NOTE: Do notstack the UPS System power module or external battery modules. UPS POWER MODULE INPUT AND OUTPUT HARDWIRE CONNECTION In addition to th...

Page 7 - TURNING THE UPS ON; TURNING THE UPS OFF

7 Installation (continued) Operation (Normal Conditions) TURNING THE UPS ON • Make sure the UPS is properly installed (see Installation section) and the Manual Bypass Switch is set to NORMAL. • Turn the AC Input and Bypass AC Input Circuit Breakers ON. • If your AC input is providing power normally ...

Page 8 - LCD DISPLAY SELECT BUTTON

8 Operation (Normal Conditions) (continued) SELF-TESTING When you turn the UPS ON, it will perform a brief self-test. See charts below for display sequences. Display sequence when AC input power is present: Display sequence when AC input power is absent: SELF TESTING... (possible only with the "...

Page 11 - DRY CONTACT INTERFACE; Communications

DRY CONTACT INTERFACE This female DB9 contact-closure port allows your UPS tosend contact-closure signals to indicate that it is in batteryback-up mode and that its batteries are running low. The portcan also receive a remote shutdown signal. DRY CONTACT INTERFACE TABLE UPS Operating Mode Pin 8,3 Pi...

Page 12 - LIMITED WARRANTY

12 Communications (continued) REMOTE EMERGENCY POWER OFF (EPO) This optional feature is only for those applications which require connection to a facility's Emergency Power Off (EPO) circuit. When thepower module is connected to this circuit, it enables emergency shutdown of the output. Using the in...

Page 13 - Specifications

Model: SU20K3/3X Includes: • Power Module • Battery Module Model: SU20K3/3INTPM Model: BP240V33 Input Input Voltage: 220/380, 230/400, 240/415V AC, 3ø, 4 wire (plus ground), wye Input Frequency 50/60 Hz ± 3 Hz (auto-selectable) Voltage Correction Range: 156-280/270-485V AC Input Current (Per Phase, ...