Tripp Lite 200812163 - Manuals

Page 2 - Important safety Instructions; sAVE tHEsE InstrUCtIOns!; or property damage could result.; Equipment Connection Warnings; power adapters that will eliminate the plug’s ground connection.; Operation Warnings; available) even though the operating mode switch is set to “DC OFF.”

2 Important safety Instructions sAVE tHEsE InstrUCtIOns! This manual contains important instructions and warnings that should be followed during the installation, operation and storage of this product. Location Warnings • Although your Inverter/Charger is moisture resistant, it is NOT waterproof. Fl...

Page 3 - Feature Identification; Configuration DIP Switches:

3 Feature Identification Identify the premium features on your specific model and quickly locate instructions on how to maximize their use. Configuration DIP Switches: optimize Inverter/Charger operation depending on your application. See Configuration section for setting instructions. Operating Mod...

Page 4 - Operation; switch Modes

4 Operation switch Modes After configuring, mounting and connecting your Inverter/Charger, you are able to operate it by switching between the following operat- ing modes as appropriate to your situation: “AUTO/REMOTE”: Switch to this mode when you need constant, uninterrupted AC power for connected...

Page 5 - Configuration; set Configuration DIP switches; resetting Your Inverter/Charger to restore AC Power

5 Configuration set Configuration DIP switches Using a small tool, set the Configuration DIP Switches (located on the front panel, see diagram) to optimize Inverter/Charger operation depending on your application. Refer to the appropriate section to review the instructions for your specific model. I...

Page 6 - group B DIP switches (select Models Only)

6 Select Battery Charger-Limiting Points“Most Limiting” (B2 & B1 Up): Charger- limiting takes effect the moment any AC load is applied; charger output falls gradu- ally from full output at no AC load passing through to no output at full load (factory set- ting). "Less Limiting" (B2 Up &a...

Page 7 - Battery selection; select Auxiliary Battery type; nected to each other.; Match Battery Amp-Hour Capacity to Your Application; tools; Appliances; • STEP 1: Determine Total Wattage Required; to determine the DC amps required.; • STEP 3: Estimate Battery Amp-Hours Required; (for operation unsupported; 5 DC Amps × 5 Hrs. runtime

7 Battery selection select Auxiliary Battery type (if any) Select “Deep Cycle” batteries to receive optimum performance from your Inverter/Charger. Do not use ordinary car or starting batteries or batteries rated in Cold Cranking Amps (CCA). If the batteries you connect to the Inverter/Charger are n...

Page 8 - Mounting; or damage to the Inverter/Charger and connected systems.; Horizontal Mount

8 Mounting WArnIng! Mount your Inverter/Charger BEFOrE DC battery and AC power connection. Failure to follow these instructions may lead to personal injury and/ or damage to the Inverter/Charger and connected systems. Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of...

Page 9 - • Connect DC Wiring:; national and local codes and ordinances.; Battery Connection; Your Inverter/Charger’s Nominal DC Input Voltage; must match; the voltage of your battery or batteries.

9 • Connect DC Wiring: Though your Inverter/Charger is a high-efficiency converter of electricity, its rated output capacity is limited by the length and gauge of the cabling running from the battery to the unit. Use the shortest length and largest diameter cabling (maximum 2/0 gauge) to fit your In...

Page 10 - AC Input Connection; ISOBAR; AC Input/Output Connection; address given to you by the Tripp Lite service technician.; Maintenance

10 To avoid overloading your Inverter/Charger, match the power requirements of the equipment you plan to run at any one time (add their total watts) with the output wattage capacity of your Inverter/Charger model (see Specifications). Do not confuse “continuous” wattage with “peak” wattage ratings. ...

Page 11 - troubleshooting; before returning your unit for service.; Limited Warranty

11 troubleshooting Try these remedies for common Inverter/Charger problems before calling for assistance. Call Tripp Lite Customer Service at (773) 869-1234 before returning your unit for service. Limited Warranty Tripp Lite warrants its Inverter/Chargers to be free from defects in materials and wor...