Timex t331 - Manuals - manualsarea.com

Page 2 - CAUTION; RISK OF ELECTRIC SHOCK.; The symbols above are located at the bottom of the cabinet.; A Consumer Guide to Product Safety

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. AVERTISSEMENT: POUR RÉDUIRE LE RISQ...

Page 4 - Table of Contents; Preparation for Use

Table of Contents FCC/IC Information Preparation for Use ............................................................................................................................................................................. 1 Controls And Indicators ..............................................

Page 5 - Preparation For Use; Battery Back-up System; FM wire antenna; • Install two “AAA” batteries in the battery compartment. Observe the

1 Preparation For Use Battery Back-up System Your new Timex Bluetooth Clock Radio has a battery back up system that will maintain the time and alarm settings during a temporary power interruption. The battery back up system requires two “AAA” batteries (not included). We recommend you use a well-kno...

Page 6 - Controls and Indicators; press to adjust hours of the time or hours of the alarm adjustment.; Controls and Their Functions; Front Panel

2 Controls and Indicators CLOCK / PRESET / PAIR Button – When the unit is OFF press & hold to enter the clock setting mode. When the FM/AM radio is active press & hold to store or recall a preset memory stations. When the BT mode is selected press & hold to activate BT pairing mode. When...

Page 7 - Back Panel

3 Controls and Indicators Battery Back UpCompartment AC Power Cord Auxiliary Input Jack FM Antenna Wire This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any in...

Page 8 - Operating Instructions; Unwind the FM wire antenna and extend it to its full length.; Setting The Current Time; button to advance; Setting The Alarm Time; Follow the same procedure to set the Alarm 2 wake-up time.

4 Operating Instructions Unwind the FM wire antenna and extend it to its full length. Unwind the AC power cord completely and insert the plug into a 120V/60Hz AC outlet. Use an outlet that is always ‘live’. Do not use an outlet that is controlled by a wall switch. When the clock is connected to the ...

Page 9 - Radio Operation; • Manual Tuning – Repeatedly press the HOUR /; Last Station Memory; 1” indicator begins flashing in the display.

NOTE: You must make the time and alarm time adjustments while the display is flashing. If no adjustments are made for approximately 8 seconds the display will stop flashing and cannot be adjusted. If this occurs you must start the time and alarm setting procedure again and make sure that you complet...

Page 10 - and the previous station is deleted.; Bluetooth Feature; bt

6 To Recall A Preset Station Tune to the desired band and then press the CLOCK / PRESET / PAIR button to scroll through the 10 preset memories to find your desired station. To Change A Preset Station 1. Tune to the new station that you want to store.2. Press and hold the CLOCK / PRESET / PAIR button...

Page 11 - above to adjust the wake-up times if necessary.

5. When you are finished listening press and hold the POWER/MODE/ALM RESET button until the display shows “OFF” and then return to the current time. If necessary turn off your Bluetooth enabled device as well. Note: If you move your Bluetooth enabled device out of range the signal will be lost and t...

Page 13 - Limited 90 Day Warranty Information

Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of ninety (90) days from the date of original purchase. Should this product fail to func...