Timex T236 - Manuals - manualsarea.com

Page 3 - Controls Overview; Rear Panel

2 Controls Overview Rear Panel Top Panel 6 Power/ Alarm Reset Button Alarm 1 Button Snooze/Sleep Display Dimmer Button Alarm 2 Button Mode Button Volume Up Button Volume Down Button Tune – / Minutes Button Tune + / Hours Button Radio Presets/ Clock Button FM Antenna DC jack USB charging port Aux-in ...

Page 4 - Set Up; Connecting to Power Source; The unit does not operate

3 6 Set Up Connecting to Power Source Connect the AC adaptor to the DC jack located on back of the unit. Connect plug into a working wall outlet that is not controlled by a wall switch. The unit does not operate on batteries (the battery backup system maintains clock settings during power failures)....

Page 5 - Adjusting the Time Zone; press and hold; Time Zone Button

4 P5 1 2 SECS TIME ZONE Adjusting the Time Zone If you are NOT in the Eastern time zone, press and hold the Time Zone Button located on back of the unit. “02” will flash in the display. 2 MINS HOURS TUNE Set Up Find the number that matches your time zone above.Press and release the TUNE+/HOURS Butto...

Page 6 - DST Switch; DST; Press and hold

Setting the Clock 1 This unit features Redi-SET and should display the correct time when first connected to power. If the time is not correct, follow these steps to set the clock manually. Make sure unit is OFF. To confirm unit is off, press and release the Power/Alarm Reset Button once or twice unt...

Page 9 - Setting and Using Alarms; Alarm 1 Button; until current alarm time flashes on the display.

P9 8 Setting and Using Alarms 1 Press and hold the Alarm 1 Button until current alarm time flashes on the display. This unit has two independent alarms, Alarm 1 and Alarm 2. Each is set and operates in the same way. Instructions below show Alarm 1. Follow the same method to set Alarm 2. 2 Press and ...

Page 10 - SELECTING YOUR ALARM SOURCE/DISARMING THE ALARM

P10 9 4 OR OR Press and release the Alarm 1 Button to complete alarm time setting. Press and release the Alarm 1 Button repeatedly as needed to cycle to desired alarm mode: Buzzer (default), Radio (last AM or FM station played) or Off (alarm is no longer active). Note that the last radio volume list...

Page 11 - Button; TIP; OR; Setting and Using the Radio; BASIC RADIO OPERATION; AM

10 P11 DISPLAY DIMMER OR Press and release the Snooze/Sleep Button when the alarm sounds to silence it for 9 minutes. Snooze can be used several times during 1 hour alarm cycle. Press and release the Power/Alarm Reset Button to turn unit On. 2 Press and release the Mode Button as needed to select AM...

Page 12 - Mode Button; Reset Button

11 P12 This unit will store up to 20 station presets, 10 AM and 10 FM. SETTING RADIO PRESETS PRESET RADIO SETTING AND OPERATION 2 Press and release the Mode Button as needed to select AM or FM radio band. 3 2 SECS 4 Press and release the TUNE+/HOURS Button or TUNE – /MIN Button to tune radio to a st...

Page 13 - PRESET RADIO OPERATION

MODE ALM RESET 12 P13 AUX IN PRESET RADIO OPERATION 3 Press and release the Mode Button as needed to select AUX mode. 1 Connect a standard audio cable with 3.5mm plug (not included) to the AUX IN jack located on the back of the unit and to the output/headphone jack of your audio device. Using Aux In...

Page 14 - Sleep Mode

13 P14 Press and hold the Snooze/Sleep Button to toggle display brightness between high and low settings. Dimmer cannot be adjusted when alarm is sounding. Sleep mode allows you to set the unit to turn off after a selected time interval. It allows you to fall asleep while listening to the radio or a...

Page 15 - Connect a USB cable (not included) to the; USB Charging Port; on the back of the; it will not charge when operating on

14 P15 Connect a USB cable (not included) to the USB Charging Port on the back of the unit and connect the other end to the device you wish to charge. Unit must be connected to AC to charge devices via USB: it will not charge when operating on batteries nor when unit is in AM radio mode (interferenc...

Page 16 - Installing and Replacing Backup Batteries; in the battery compartment.

AUX-IN DC 5V TIME ZONE DST Installing and Replacing Backup Batteries Press AUX-IN DC 5V TIME ZONE DST Your new Timex Clock Radio includes 2 AA batteries (installed). This battery backup system will maintain the time and alarm settings during a temporary power interruption. When the Battery Low Indic...

Page 17 - IMPORTANT SAFETY INSTRUCTIONS

When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instr...

Page 19 - Limited 90 Day Warranty Information

18 P19 Limited 90 Day Warranty Information Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of ninety (90) days from the date of original...