TANDBERG MSE 8350 - Manuals

2 LED behavior Table 1 describes the behavior of the LEDs. Table 1: IP GW blade LED behavior LED Color Indicates Compact Flash Activity Flashing green One of: the IP GW blade is booting a configuration change has been made the configuration is being transferred by FTP Console Link Green A PC is conn...

4 Installing the IP GW blade For information about powering the MSE 8000, refer to the Getting Started Guide that accompanied the chassis. Step one: Install the IP GW blade into the MSE 8000 chassis 1 Remove the blade or blanking blade from the slot into which you are going to install the IP GW blad...

6 Step two: Connect to Ethernet Ports A and B Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a hub, to minimize interference from other devices on the network). The Ethernet port is a 10/100/1000 Mbps auto-sensing connection.Connect Port A to your local network and...

Initial configuration 7 Initial configuration Step one: Configure Ethernet Ports A and B The default setting for the IP GW blade Ethernet ports is auto-sensing mode. If the switch ports to which you connect the IP GW blade are not also set to auto-sensing mode, then you need to configure the IP GW b...

8 Configuring the IP GW blade Step one: Log in to the IP GW blade All administration of the IP GW blade is performed through the web interface.To log in to the web interface of the IP GW blade:1 Log in to the Supervisor’s web interface. 2 Go to Hardware > Blades and click the IP address of the IP...

Configuring the IP GW blade 9 Step three: Configure the auto attendant menus (optional) Depending on the proposed configuration of your dial plan, and the settings for failed calls, callers can be connected to an auto attendant menu. The IP GW blade provides a highly flexible menu-creation feature. ...

10 Step five: Add endpoints and call groups (optional) You can pre-configure a list of endpoints on the IP GW blade. For these endpoints, an operator or caller can simply choose the endpoint's name from an onscreen address book, rather than having to type in the endpoint's address when a caller want...

Checking for updates 11 Checking for updates It is a good idea to regularly check for updates to the main IP GW blade software image. This section describes how to upgrade the IP GW blade using the web interface. Note that you can also upgrade the IP GW blade using FTP; this can be more reliable if ...

12 Troubleshooting and technical support information Using the event log to help solve a problem Unless you are experiencing a problem, all event logging sources should be set to the default, which is Errors, warnings and information . For more information about configuring the event log, refer to t...