Smeg SRA975BGH - Manuals - manualsarea.com

Page 2 - Introduction; INSTRUCTIONS FOR SAFE AND PROPER USE

Introduction 4 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE HOB. IN...

Page 3 - The manufacturer declines all responsibility; for damage to

Introduction 5 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE DUPLICATE DATA PLATE MUST BE ATTACHED TO AN ADJACENT SURFACE. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHE...

Page 4 - Instructions for the installer; POSITIONING OF THE HOB; It is the law that all gas appliances are installed by; Attachment to support structure; from the; on the inner side

Instructions for the installer 6 2. POSITIONING OF THE HOB It is the law that all gas appliances are installed by authorised persons . Clearance around the appliance must comply with the requirements of AS5601. The following operation requires building and/or carpentry work so must be carried out by...

Page 5 - Clearance above and around domestic appliances

Instructions for the installer 7 60 CM HOB 70 CM HOB A 60 120 B 90 90 C 30 30 D 90 70 2.2 Clearance above and around domestic appliances Extract from AS5601

Page 6 - REQUIREMENTS

Instructions for the installer 8 REQUIREMENTS 1 Overhead clearances – (Measurement A ) Range hoods and exhaust fans shall be installed in accordance with the manufacturer’s instructions. However, in no case shall the clearance between the highest part of the highest burner of the cooking appliance a...

Page 7 - Room ventilation; Caution; – This hob may only be installed and operated in rooms; Discharge of combustion products; mm; between the bottom of the hob and the surface of the panel, which

Instructions for the installer 9 2.3 Room ventilation Caution – This hob may only be installed and operated in rooms permanently ventilated in accordance with current regulations, AS/NZS5601. 2.4 Discharge of combustion products Discharge of combustion products must be guaranteed by means of hoods c...

Page 8 - GAS CONNECTION; annealed copper pipe or

Instructions for the installer 10 3. GAS CONNECTION This appliance is suitable for installation with Natural Gas or ULPG (propane). Refer to page 13 and 14 for the relevant burner pressure and appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulato...

Page 9 - ELECTRICAL CONNECTION; Do not remove this; , located in an easily accessible; The manufacturer will not be liable; for any damage to persons or

Instructions for the installer 11 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason. The plug on the end of the supply cable and the wall socket must be the same ...

Page 10 - ADAPTATION TO DIFFERENT TYPES OF GAS; Before performing any cleaning or maintenance work, detach the; natural gas; Removing the hob

Instructions for the installer 12 5. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been adjusted for natural gas at a pressure of 1.0kPa. For functioning with other types of gas the nozzles must b...

Page 11 - Adjustment for natural gas; The hob has been adjusted for

Instructions for the installer 13 Burner (*) ULPG – 2.75 kPa Nominal gas consumption (MJ/h) Injector (mm) Auxiliary (1) 4.8 0.60 Semi rapid (2) 6.0 0.68 Rapid (6) 9.5 0.85 Rapid (3) 12.5 0.95 Wok (4) 15.0 1.05 Wok (dual control) (5) 18.2 - Outer 14.4 0.98 Inner 3.8 0.48 (*) For burner reference numb...

Page 12 - FINAL OPERATIONS; Adjustment of minimum for natural gas; Light the burner and take it to the minimum; Arrangement of burners on the hob; Burners; Lubrication of gas taps; This operation must be done

Instructions for the installer 14 6. FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, the instructions in paragraph “5.1 Removing the hob”. 6.1 Adjustment of minimum for natural gas Light the burner and take it to the minimum . Remove the gas ...

Page 13 - USING THE HOB; Adapter; Ignition of the burners

Instructions for the installer 15 7. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly. In the wok burner, the flame spreader crowns must be correctly positioned in their seats. Grid C provided is intended for use with woks (Chine...

Page 14 - Instructions for the user; Practical advice for using the burners; CLEANING AND MAINTENANCE; Cleaning

Instructions for the user 16 7.2 Practical advice for using the burners For better use of the burners and lower gas consumption, use covered containers that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph “7.3 Diameter of containers”). When water rea...

Page 15 - Regular daily cleaning of the hob; , which do not contain abrasive substances or chlorine-based acid; Food stains or residues; Cleaning of the hob components; to fully dry out; Preventive maintenance; the burners must be cleaned after every use to ensure correct

Instructions for the installer 17 8.1.1 Regular daily cleaning of the hob In order to clean and preserve the surface, always use specific products only , which do not contain abrasive substances or chlorine-based acid substances. How to use: pour the product on a damp cloth and wipe the surface, rin...

Page 16 - if a flexible pipe is used, it must be inspected periodically; PROBLEMS AND CAUSES; PROBLEM; Call Service Center.

Instructions for the user 18 Flexible pipes: if a flexible pipe is used, it must be inspected periodically (once a year) for leakages: if the surface of the pipe appears rigid and cracked, disconnect immediately the cooker from the gas supply and replace the pipe with a new one. Valves: if the gas v...