Smeg CW511MDA-2 - Manuals

6 CW/CWH 511 KEY TO LETTERS USED IN DIAGRAM R LOWER BACK PANEL Q EARTH TERMINAL P PERISTALTIC PUMP HOSES E ELECTRICITY SUPPLY CABLE S DRAIN HOSE T FILLER HOSE C EXTERNAL DISPENSER POWER SUPPLY CABLE ENTRY POINT 3 INSTALLATION AND POSITIONING INSTALLATION and POSITIONING Bring the dishwasher to the i...

7 CW/CWH 511 4 INSTRUCTIONS FOR TECHNICAL STAFF 4.1 Plumbing hookup PLUMBING HOOKUP The water pipelines and electricity supply cable lead out of the bottom right-hand corner of the appliance. Connect the water intake hose to a connector with ¾” gas threaded fitting, fitting the filter A provided (in...

8 CW/CWH 511 5 FIRST START-UP First start-up The electrical protection system must undergo a functional test before the appliance is put into operation. The appliance must be installed and/or inspected by qualified staff, who will start it up for the first time and provide the relevant operating ins...

11 CW/CWH 511 6.4 Modifiable parameters This table lists the model choice or programme and temperature option parameters. Display Settings available Description °b From 85° to 71° Boiler temperature °t From 62° to 52° Tank temperature St On - OF Auto-start: washing programme starts when door is clos...

12 CW/CWH 511 6.6 Starting the peristaltic pumps in manual mode – rapid filling of detergent and rinse aid circuit With the dishwasher powered up and the tank full, press the buttons simultaneously for 5” The peristaltic pumps continue to operate until one of the 2 buttons is pressed again; the ligh...

13 CW/CWH 511 7 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE TECHNICIAN) The dishwasher is able to identify a number of malfunctions and show them on the display. If the problem persists after the dishwasher has been switched off and back on, proceed as described below: Er 04 Tank temperature probe ma...

14 CW/CWH 511 8 INSTRUCTIONS FOR THE USER 8.1 Control panel Key to Symbols On/off button Total pump-out (tank -boiler) button Regeneration button (only if softener is fitted) Regenerating salt symbol (only if softener is fitted) Short programme button Medium programme button Long programme button L1...

17 CW/CWH 511 Unload the dishes When the door is closed again, the system offers the last program run. 8.4 Choosing the program Single-phase Three-phase SYMBOL PROGRAM TYPE OF DIRT DURATION (*) DURATION (*) Short Glasses and cups 2” 1.5” Medium Glasses, cups and plates with light dirt 2.5” 2” Long V...

18 CW/CWH 511 Plates Plates The basket is able to take 12 soup plates or 18 dinner plates. Remove solid residues (bones, fruit peel, stones, etc.) and first soak plates with dried residues of cheese, egg, etc. in water. TOTAL PUMP-OUT AT THE END OF THE DAY Press the pump-out button for about 5”, the...

19 CW/CWH 511 Topping up with regenerating salt (for models with softener) Warning: use only salt of the specific type, do not use cooking salt. Salt must be added when the Led underneath the symbol shown in the box on the left lights up. Top up with salt when there is no water in the tank to preven...

20 CW/CWH 511 9.3 Lengthy periods out of use If the dishwasher is to be out of use for a fairly long period of time, the detergent and rinse aid dispenser devices must be emptied to prevent crystallisation and damage to the pumps: Remove the intake hoses from the detergent and rinse aid containers a...

21 CW/CWH 511 11 MALFUNCTIONS SHOWN ON THE DISPLAY (FOR THE USER) The dishwasher is able to identify a number of malfunctions and show them on the display. If the problem persists after the dishwasher has been switched off and back on, proceed as described below: ERROR POSSIBLE CAUSE POSSIBLE REMEDY...

The information in this manual s provided for guidance only. The contents and the equipment described may be subject to change without notice Les information continues dans ce mode d’emploi ne sont publiée qu’à titre informatif. Ces informations et l’appareil décrit peuvent faire l’objet de modifica...