Shop Fox D4031 - Manuals

Shop Fox D4031 – Manual in PDF format online.

Manuals:

Manual

Manual Shop Fox D4031

Summary

Page 2 - D4031 Mortising Kit Instructions; Mounting the Cone; Inventory; Mounting the Fence; Figure 4

-2- D4031 Mortising Kit Instructions Mounting the Cone 1. If the cone will not fit over the drill chuck, remove the chuck. Otherwise, secure the alignment tool in the drill chuck on your drill press. 2. Carefully measure the flange on the bottom of the quill on your drill press. 3. Compare the size ...

Page 3 - Making a Mortise; opening is positioned toward the operator and is; Figure 5; then; Figure 6; resulting in excessive heat and damage to the tool.; Figure 7; Proper drill bit depth.

-3- D4031 Mortising Kit Instructions Making a Mortise Proper alignment of the workpiece and chisel is essential to making good mortise and tenon joints. The instructions below describe one method of creating square joints with an evenly-spaced mortise. Place a scrap board on top of the drill press t...

Page 4 - Cut Sequence; Cutting mortises that are wider than the chisel must be; Figure 8; one possible sequence that will produce good results.; Figure

-4- D4031 Mortising Kit Instructions REF PART # DESCRIPTION 1 XD4031001 ALIGNMENT TOOL 2 XD4031002 CLAMP ROD 3 XD4031003 LARGE T-NUT 5/16-18 4 XD4031004 SMALL T-NUT 5/16 X 18 5 XD4031005 FENCE 6 XD4031006 HOLD-DOWN ROD 7 XPW07 FLAT WASHER 5/16 8 XD4031008 HANDLE MALE 5/16-18 X 2" 9 XD4031009 HOL...