SEAGATE ST6000VN001 - Manuals

Seagate IronWolf Product Manual, Rev. A 5 For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visi...

Seagate IronWolf Product Manual, Rev. A 6 1.0 Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate® IronWolf® and model drives: These drives provide the following key features: • 1M hour MTBF - designed for high write duty cycle across ...

Seagate IronWolf Product Manual, Rev. A 7 www.seagate.com Introduction 1.1 About the SATA interface The Serial ATA (SATA) inter face provides several advantages over the traditional (parallel) ATA inter face. The primar yadvantages include: • Easy installation and configuration with true plug-and-pl...

Seagate IronWolf Product Manual, Rev. A 8 2.0 Drive Specifications Unless other wise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. Forconvenience, the phrases the drive and this drive are used throughout this manual to indicate the following drive model...

Seagate IronWolf Product Manual, Rev. A 10 www.seagate.com Drive Specifications 2.2 Formatted capacity *One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. 2.2.1 LBA m...

Seagate IronWolf Product Manual, Rev. A 11 www.seagate.com Drive Specifications 2.5 Physical characteristics 2.6 Start/stop times The start/stop times are listed below. Time-to-ready may be longer than normal if the drive power is removed without going through normal OS powerdownprocedures. Maximum ...

Seagate IronWolf Product Manual, Rev. A 12 www.seagate.com Drive Specifications 2.7 Power specifications The drive receives DC power (+5V or +12V ) through a native SATA power connector. Refer to Figure 1 on page 22 . 2.7.1 Power consumption Power requirements for the drives are listed in Table 2 . ...

Seagate IronWolf Product Manual, Rev. A 14 www.seagate.com Drive Specifications 2.8 Environmental specifications This section provides the temperature, humidity, shock , and vibration specifications for IronWolf drives. Ambienttemperature is defined as the temperature of the environment immediately ...

Seagate IronWolf Product Manual, Rev. A 15 www.seagate.com Drive Specifications 2.8.4 Altitude 2.8.5 Shock All shock specifications assume that the drive is mounted securely with the input shock applied at the drive mountingscrews. Shock may be applied in the X, Y or Z axis. 2.8.5.1 Operating shock ...

Seagate IronWolf Product Manual, Rev. A 16 www.seagate.com Drive Specifications 2.9 Acoustics Drive acoustics are measured as overall A-weighted acoustic sound power levels (no pure tones). All measurements areconsistent with ISO document 7779. Sound power measurements are taken under essentially fr...

Seagate IronWolf Product Manual, Rev. A 17 www.seagate.com Drive Specifications 2.11 Warranty To determine the warranty for a specific drive, use a web browser to access the following web page: http://www.seagate.com/support/warranty-and-replacements/ From this page, click on “Is my Drive under Warr...

Seagate IronWolf Product Manual, Rev. A 18 www.seagate.com Drive Specifications 2.12.3 Australian RCM Compliance Mark If these models have the RCM marking, they comply with the Australia/New Zealand Standard AS/NZ CISPR32 and meetthe Electromagnetic Compatibility (EMC) Framework requirements of the ...

Seagate IronWolf Product Manual, Rev. A 19 www.seagate.com Drive Specifications 2.12.8 FCC verification These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as anexternal device). As such, each drive is considered to be a subassembly even whe...

Seagate IronWolf Product Manual, Rev. A 20 2.13.1.2 Substances of Very High Concern (SVHC) The European Union REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) Regulation (EC) 1907/2006 regulates chemicals shipped into and used in Europe. A number of parts and materials in...

Seagate IronWolf Product Manual, Rev. A 21 www.seagate.com Drive Specifications 2.13.3 Taiwan Requirements — Taiwan RoHS Taiwan RoHS refers to the Taiwan Bureau of Standards, Metrology and Inspection’s (BSMI) requirements in standard CNS 15663, Guidance to reduction of the restricted chemical substa...

Seagate IronWolf Product Manual, Rev. A 22 3.0 Configuring and Mounting the Drive This section contains the specifications and instructions for configuring and mounting the drive. 3.1 Handling and static-discharge precautions After unpacking, and before installation, the drive may be exposed to pote...

Seagate IronWolf Product Manual, Rev. A 23 www.seagate.com Configuring and Mounting the Drive 3.4 Drive mounting Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 2 for drive mounting dimensions. Fol...

Seagate IronWolf Product Manual, Rev. A 24 www.seagate.com SATA Interface 4.0 SATA Interface These drives use the industr y-standard Serial ATA (SATA) inter face that suppor ts FIS data transfers. It suppor ts ATAprogrammed input/output (PIO) modes 0 to 4; multiword DMA modes 0 to 2, and Ultra DMA m...

Seagate IronWolf Product Manual, Rev. A 25 www.seagate.com SATA Interface 4.3 Supported ATA commands The following table lists SATA standard commands that the drive supports.For a detailed description of the ATA commands, refer to the Serial ATA International Organization:Serial ATA Revision 3.2 ( h...

Seagate IronWolf Product Manual, Rev. A 27 www.seagate.com SATA Interface 4.3.1 Identify Device command The Identify Device command (command code EC H ) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are ...

Seagate IronWolf Product Manual, Rev. A 33 www.seagate.com SATA Interface 4.3.3 S.M.A.R.T. commands S .M .A .R .T. prov id e s n e a r- te r m f a il u re p re d i c t i o n fo r d is k d r i ve s. W h e n S . M . A . R . T. i s e n a b l e d, t h e d r i ve m o n i t o r spredetermined drive attrib...

Seagate Technology LLC AMERICAS Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, United States, 408-658-1000 Publication Number: 100856098 , Rev. A July 2019