SATO M-10e - Manuals

M-10e Quick Guide Pg 3 Components M-10e Quick Guide Pg 12 Using the Universal Serial Bus (USB) Interface If nothing prints when doing a test print, you will need to verify that the device drivers have been successfully installed by doing the following: 1) Click on Start, then Settings and then Contr...

M-10e Quick Guide Pg 5 Media Loading Ribbon Loading (not applicable for the M-10e DT) 1. Open the Top Cover to expose the ribbon mechanism… 2. Open the Print Head by pulling forward on the purple Head Latch lever on the right hand side of the ribbon mechanism. 3. Lift the Print Head by rotating it u...

M-10e Quick Guide Pg 9 Head Check Selection (DSW2-3) – When selected, the printer will check for head elements that are electrically malfunctioning. Hex Dump Selection (DSW2-4) – Selects Hex Dump mode. Receive Buffer Selection (DSW2-5) – Selects the operating mode of the receive buffer. Firmware Dow...

M-10e Quick Guide Pg 7 Operation Panel LCD Display 2 Lines x 16 Character display POWER LED Illuminated when power is applied ERROR LEDs Illuminated when errors occur ON-LINE LED Illuminated when printer is On-Line LINE Key Switches the printer On-Line or Off-Line. It can also be used as a Pause fun...