Page 2 - Contents
English 2 Contents Contents Safety information 3 Important safety symbols 3 General 4Vacuum cleaner 4 Maintenance 7Charging stand 8 Battery 10 Preparation 12 Accessories 12Parts overview 13 Operation 14 Installing the charging stand 14 Using the charging stand 15 Charging the battery 16 Inserting th...
Page 3 - and retain it for your reference.; Important safety symbols; Indicates that a danger of death or serious injury exists.; CAUTION
English 3 Safety information • Before operating the appliance, please read this manual thoroughly and retain it for your reference. • Because the following operating instructions cover various models, the characteristics of your vacuum cleaner may differ slightly from those described in this manua...
Page 4 - General; Vacuum cleaner
Safety information English 4 Safety information General For information on Samsung’s environmental commitments and product regulatory obligations, e.g. REACH, visit our sustainability page available via www.samsung.com Failure to meet these requirements could cause damage to the internal parts of th...
Page 7 - Maintenance; • While using or after using the vacuum cleaner, you should lay the
English 7 Safety information Maintenance • While using or after using the vacuum cleaner, you should lay the vacuum cleaner down or place it on the charging stand to store. – The product may fall and an injury and severe product damage occur. In addition, you may not be compensated for the damage....
Page 8 - Charging stand
Safety information English 8 Safety information Washable Parts Dustbin, Washable Micro Filter, Fine Dust Filter, Metal Mesh Grille Filter, dry cloth Acceptable detergent Neutral Dish washing detergent Prohibited detergent Alkaline Lox, mold cleaner, etc. Acid Paraffin oil, an emulsifier, etc. Indust...
Page 10 - Battery
Safety information English 10 Safety information • Do not attempt to open the charging stand. Repairs should be only carried out by a qualified Samsung service center. • Injury or product malfunction from incorrect installation of the charging stand may not be compensated. • Do not bend the power co...
Page 11 - • Leaks from battery cells can occur under extreme usage or
English 11 Safety information • Leaks from battery cells can occur under extreme usage or temperature conditions. If the liquid gets on your skin, wash the affected area quickly with water. If the liquid gets into your eyes, flush them immediately with clean water for a minimum of 10 minutes. Seek...
Page 12 - Preparation; Accessories
English 12 Preparation Accessories The accessories with the ' * ' mark may differ depending on the models. Telescopic pipe Pet Tool+ Combination Tool Extension Crevice Tool Flexible Tool User manual * Jet Dual Brush * Slim LED Brush Charging stand * Disposable wet pads / Attachable pad * Spray Spinn...
Page 13 - Parts overview
English 13 Pr epar ation Parts overview 12 16 17 18 14 13 10 11 05 15 06 09 07 08 01 03 04 02 01 Power ( ) button 02 Suction power control buttons 03 Washable Micro Filter 04 Metal Mesh Grille Filter 05 Display 06 Dustbin release button 07 Fine Dust Filter 08 Dustbin 09 Adjustable pipe 10 Handle 1...
Page 14 - Operation; Installing the charging stand
English 14 Operation Installing the charging stand ᎃ)& (ᎅ 2 1 3 4 1. Place the stand pipe on the bottom support, and screw the pieces together using the included small screw. - Make sure the pieces are aligned correctly and push it in firmly so that the screw hole is aligned. 2. Insert the vacuu...
Page 15 - Using the charging stand; Charging
English 15 Oper ation Using the charging stand Charging • Make sure the back of the battery is correctly placed onto the vacuum charging part. • Check if the battery level indicator is displayed while charging. • The battery level indicator blinks while charging. When charging is complete, the bli...
Page 16 - Storing the accessories; Charging the battery
Operation English 16 Oper ation Storing the accessories • When accessories are disassembled to be stored, dust may fall from the suction part of the vacuum cleaner. • After cleaning, shorten the pipe length and operate in MAX mode for 10 seconds. Storing the Spray Spinning Sweeper When the brush hol...
Page 17 - Inserting the battery; Ejecting the battery; Charging the additional battery
English 17 Oper ation Inserting the battery ᎃ)& (ᎅ Push the battery to the end until you hear it click. Ejecting the battery Press the battery release button at the rear of the handle to eject the battery. CAUTION • Before ejecting the battery, the vacuum cleaner must be turned off. - The vacu...
Page 18 - Using the buttons and display; Alert messages
Operation English 18 Oper ation Using the buttons and display 8: 89 8; 01 Display - Displays the current mode (‘ MIN , MID , MAX , JET , or WET ’) or the alert message. 02 Power ( ) - Press this button to turn on or off the vacuum cleaner. - When you turn on the power, the vacuum cleaner starts in t...
Page 19 - Using the accessories; Detaching the accessories; Combination Tool
English 19 Oper ation Using the accessories Detaching the accessories • To detach the accessories, press the release button on the back of each accessory. • Before detaching the accessories, operate the vacuum cleaner in the ' MAX ' mode for 10 seconds to prevent any foreign matter remains inside ...
Page 20 - Spray Spinning Sweeper; Adjusting the pipe length
Operation English 20 Oper ation Spray Spinning Sweeper Reusable wet pad Disposable wet pad Attachable pad Attaching Detaching After use <Front> <Back> Spin disk Velcro Use to clean a wood and linoleum floor with a wet pad.• The Spray Spinning Sweeper does not have a dust suction function...
Page 21 - Cleaning the vacuum cleaner; Dustbin/Washable Micro Filter
English 21 Maintenance Cleaning the vacuum cleaner Dustbin/Washable Micro Filter 1 2 3 4 5 24H 6 7 ᎃ)& (ᎅ 8 9 1 2 ᎃ)& (ᎅ ᎃ)& (ᎅ CAUTION • After cleaning the dustbin and Washable Micro Filter with water, you should dry them completely in the shade for more than 24 hours before use. - Wh...
Page 22 - Fine Dust Filter; Jet Dual Brush
Maintenance English 22 Maint enanc e Fine Dust Filter Make sure to turn off the product before cleaning the filter. 24H • Twist and pull off the Fine Dust Filter, and tap it gently to remove the dust.• Wash the filter with running water once a month to maintain the best performance of the filter.• A...
Page 23 - Slim LED Brush
English 23 Maint enanc e Slim LED Brush 9 : 1 9 : ; 2 3 4 ‘Click’ 5 CAUTION • Do not clean the brush with water. • When foreign matter remains on the brush, remove it with a wet tissue or a dry cloth. NOTE • If the spin brush does not work after cleaning the Slim LED Brush, the overheating prevent...
Page 24 - Slim LED Brush roller wheels; Front roller wheel
Maintenance English 24 Maint enanc e Slim LED Brush roller wheels Front roller wheel Rear roller wheel Use a small screwdriver to disassemble the front and rear roller wheels. NOTE Tools required for disassembly. Flat head screwdriver (3 mm or less in width), Phillips screwdriver, prying tool. CAUTI...
Page 25 - Rear roller wheel
English 25 Maint enanc e Rear roller wheel 1 Release lever 2 3 4 5 ‘Click’ Release lever 6 • Lift the release lever to detach the rear roller wheel.• Detach the rear roller wheel and remove the tangled foreign matter. Then, reassemble the wheel.• Insert the rear roller wheel into its place, and th...
Page 26 - Extension Crevice Tool / Telescopic Pipe
Maintenance English 26 Maint enanc e Spray Spinning Sweeper NOTE If the spin disk does not work after cleaning the Spray Spinning Sweeper, the overheating prevention device of the motor may have been enabled. Wait 30 minutes or more to cool the motor and operate again. Pet Tool+ 1 2 Cut the tangled ...
Page 27 - Notes and cautions; Installation
English 27 Appendix Notes and cautions Installation CAUTION • Do not install the product near water, in an area with excessive moisture, or near window, etc. • Do not place the charging stand in a place where people pass by frequently, in entrance way or narrow passage. – People may trip over it a...
Page 28 - Battery usage
Appendix English 28 Appendix Battery usage NOTE • If the product does not work after you charge the battery, replace the battery. If it still does not work with the new battery, contact a Samsung service center. CAUTION • Do not disassemble the battery or the charging stand.• Do not apply heat to th...
Page 32 - Troubleshooting
Appendix English 32 Appendix Troubleshooting Before calling for service, review the problems and solutions below. Note that you will be charged for any service calls in which no defects were found. Problem Solutions The vacuum cleaner does not work. • Check the battery level and charge the battery.•...
Page 34 - Product specification
Appendix English 34 Appendix Product specification Charging and cleaning time may differ depending on the brushes and the conditions of use. Model VS20C95**** Series Power consumption (Vacuum cleaner) Based on a handy vacuum cleaner: 580 W Battery specification Li-ion 25.2 V, 2200 mAh, 7 cell Weight...
Page 35 - Memo