Rotel FR01273 - Manuals - manualsarea.com

Page 2 - A12MKII Stereo Integrated Amplifier; Notice; Important Safety Instructions

2 A12MKII Stereo Integrated Amplifier You must allow a minimum 10 cm or 4 inches of unobstructed clearance around the unit. WARNING: The rear panel power cord connector is the mains power disconnect device. The device must be located in an open area that allows access to the cord connector.The unit ...

Page 3 - Органы управления и разъемы; r t y u

3 Figure 1: Controls and Connections Commandes et Branchements Bedienelemente und Anschlüsse Controles y Conexiones Controlli e connessioni De bedieningsorganen en aansluitingen Kontroller och anslutningar Органы управления и разъемы POWER PHONES PHONO TUNER CD USB OPT COAX AUX PC-USB BT 5V / 2.1A M...

Page 4 - Mando a Distancia RR-AX1400

4 A12MKII Stereo Integrated Amplifier A B C D E F GH I N L K J M Figure 2: Remote Control RR-AX1400 Télécommande infra-rouge RR-AX1400 Fernbedienung RR-AX1400 Mando a Distancia RR-AX1400 Telecomando RR-AX1400 De afstandsbediening RR-AX1400 Fjärrkontroll RR-AX1400 Пульт ДУ RR-AX1400

Page 5 - Подсоединение источников сигнала и акустических систем

5 Figure 3: Preamp Input and Speaker Output Connections Branchements des entrées sources et sorties enceintes acoustiques Anschlussdiagramm Conexiones para Entrada de Señal y Salida a las Cajas Acústicas Collegamenti ingressi e diffusori De signaalingangen en de luidsprekeruitgangen Signal- och högt...

Page 7 - Подсоединение 12-В триггерного сигнала

7 Figure 5: 12V Trigger Connections Branchements trigger 12 V 12V-Trigger-Anschlüsse Conexiones para Señal de Disparo de 12V CLASS 1LASER PRODUCT APPAREIL LASER DE CLASSE 1 RP-600A T14 NETWORK TUNER R ANTENNA FM DAB L OUTPUT COAXIAL OUT USB RS232 12V TRIGGER IN OUT OUT ROTEL LINK OUT RP-571C WIFI AN...

Page 8 - Важные замечания

8 A12MKII Stereo Integrated Amplifier Important Notes When making connections be sure to: 4 Turn off all the components in the system before hooking up any components, including loudspeakers. 4 Turn off all components in the system before changing any of the connections to the system. It is also rec...

Page 10 - The RR-AX1400 Remote Control

10 A12MKII Stereo Integrated Amplifier A Few Precautions WARNING: To avoid potential damage to your system, turn off ALL the components in the system when connecting or disconnecting the loudspeakers or any associated components. Do not turn the system components back on until you are sure all the c...

Page 11 - Protection Indicator; Input Signal Connections; Preamp Output; Speaker Outputs

11 Protection Indicator 2 The amplifier has both thermal and over-current protection circuitry that protects the amplifier against damage in the event of extreme or faulty operating conditions. The protection circuits are independent of the audio signal and have no impact on sonic performance. Inste...

Page 12 - Volume Control

12 A12MKII Stereo Integrated Amplifier If you are using terminal lugs, connect them to the wires. If you are attaching bare wires directly to the binding posts, separate the wire conductors and strip the insulation from the end of each conductor. Be careful not to cut into the wire strands. Unscrew ...

Page 13 - Source Input Selector; Dimmer Control; Display Dimmer; Rotel Link

13 A properly setup high-performance audio system produces the most natural sound with little or no adjustment of the tone controls. Use these controls sparingly. Be particularly careful when turning the controls up. This increases the power output in the bass or treble range, increasing the load on...

Page 14 - Settings Menu

14 A12MKII Stereo Integrated Amplifier Settings Menu You can access the SETUP menu from the front panel by pressing the MENU 9 button or the K button on the remote. You can change the value of the selected option by pressing the - or + buttons on the front panel or the up/down/left/right C arrow but...

Page 15 - Troubleshooting; Power Indicator Is Not Illuminated

15 • PC-USB CLASS: Changes supported PC-USB Audio Class of the attached device. NOTE: Some computers attached to the PC-USB do not support USB Audio Class 2.0 and do not support 24/192 audio playback. If needed the PC-USB can be configured for USB Audio Class 1.0. Please consult your computer operat...

Page 16 - Specifications

16 A12MKII Stereo Integrated Amplifier Specifications Maximum Power Output 118 watts/ch, 4 Ohms Continuous Power Output 60 watts/ch, 8 Ohms Total Harmonic Distortion < 0.018% Intermodulation Distortion (60 Hz : 7k Hz, 4:1) < 0.03% Frequency Response Phono Input 20 Hz - 20k Hz, 0 ± 0.5 dB Line ...