Regency P33-NG3 - Manuals

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION IMPORTANT: SAVE THESE INSTRUCTIONS The P33-NG3 or P33-LP3 Direct Vent Fireplace must be installed in accordance with these in-structions. Carefully read all the instructions in this manual fi rst. Consult the "authority having ju...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace COMBUSTIBLE MANTELS INSTALLATION Clearances for Bay or Flush Front Because of the extreme heat this fi replace emits, the mantel clearances are critical. Com- bustible mantel clearances from top of unit are shown in the diagram below. Note: A non...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace 16-1/2” (419mm) Minimum 4" (102mm) 3" (76mm) 1-1/2" (38mm) 30” (762mm) 10" (254mm) dia. Hole through wall for Dura-Vent 1/2"(13mm)Drywall Top Header Opening for gas connection INSTALLATION 3) For exterior walls, insulate the ...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace The Top Facing Support, the Side Nailing Strips and the 2 Top Standoffs must be correctly po-sitioned and attached to the top before the unit is put into position. Top Standoff Assembly The top standoffs are shipped in a fl at position and must b...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace EXTERIOR VENT TERMINATION LOCATIONS INSTALLATION . B B B B A C V V V V V V V A A V Fixed Fixed Openable Closed Closed Openable N L B E B M D F K H j V ertical T ermination V V ent terminal Area where terminal is not permited A Air supply outlet ...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Wherever necessary due to external location of cap, the AstroCap can be replaced with the FPI Riser Vent Termination Cap or the Dura-Vent Snorkel Termination Cap. 6-7/8" (173mm) dia. Flue pipe 4" (102mm) dia. flue pipe Wall Thimble (2 pc...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Termination Cap Wall Thimble 2 pieces (10" (254mm) Outer Diameter) 2” x 4” or 2” x 6” (21mm x 102mm or 21mm x 152mm) 6-7/8" (175mm) dia. air intake 4" (102mm) dia. flue pipe with spring spacer Screws (4 per connection) Screws (3 per ...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Pipe Length Vertical Terminal Storm Collar Flashing Ceiling Firestop 24" (610mm) Pipe Length Adj.Pipe Length 11" - 14-5/8" (279mm - 372mm) 90 Elbow o Horizontal Termination Cap Wall Thimble Vinyl Siding Standoff (Optional) Rigid Pipe...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION RIGID PIPE VENTING COMPONENTS LIST All Simpson Dura-Vent components are available directly from FPI. Description Simpson Dura-Vent Selkirk Amerivent R Direct VentGS R Direct-Temp TM Direct Vent 6" Pipe Length, Galvanized 908 4DT...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION • Vent must be supported at offsets.• Firestops are required at each fl oor level and whenever passing through a wall.• Maintain clearances to combustibles. Note: Must use optional rigid pipe adapter when using rigid pipevent systems...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace RIGID PIPE VENTING ARRANGEMENTS - HORIZONTAL TERMINATIONS REGENCY DIRECT VENT SYSTEM (FLEX) (Propane & Natural Gas) This diagram shows all allowable combinations of vertical runs with horizontal terminations, using one 45 o and one 90 o elbo...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Horizontal Venting with Two (2) 90 o Elbows Horizontal Venting with Two (2) 90 o Elbows Horizontal Venting with Three (3) 90 o Elbows Option H V H + H1 + H2 A) 1 Max. 1' Min. 3' Max. B) 2' Max. 3' Min. 5' Max. C) 3' Max. 5' Min. 6' Max. D) 4' Ma...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Horizontal Venting with Three (3) 90 o Elbows Vertical Venting with Two (2) 90 o Elbows Option V H V + V1 A) 1' Min. 4' Max. 2' Min. B) 2' Min. 5' Max. 3' Min. C) 3' Min. 6' Max. 4' Min. D) 4' Min. 7' Max. 5' Min. E) 5' Min. 8' Max. 6' Min. Vert...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION Vertical Venting with Three (3) 90 o Elbows Vertical Venting with Three (3) 90 o Elbows Option H V H + H1 V + V1 A) 1' Max. 1' Min. 3' Max. 3' Min. B) 2' Max. 2' Min. 4' Max. 5' Min. C) 3' Max. 3' Min.' 5' Max. 7' Min. D) 4' Max. 4'...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Flex Liner Exhaust Flue A maximum of two certified joiner kits may be used per length. #948-305 35 ft (11m) Air Intake Co-linear DV Vertical Termination Cap # 946-529 Co-Linear Flex Adapter with Kit# 946-563 Outer Pipe with Kit# 946-563 Inner Pi...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Venting Arrangements - Vertical Terminations with Co-linear Flex System for bothResidential & Manufactured Homes into Masonry Fireplaces The shaded area in the diagrams show the allowable vertical terminations. INSTALLATION

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION Diagram 3 HORIZONTAL INSTALLATIONS Diagram 1 b) Horizontal runs of vent must be sup- ported every three feet. Wall straps are available for this purpose. 5) Mark the wall for a 10" x 10" square hole. The center of the square...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION GAS LINE INSTALLATION The gas line is brought through the right side of the appliance. The gas valve is situated on the right hand side of the unit and the gas inlet is on the right hand side of the valve. The gas line connection ma...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace GAS PIPE PRESSURE TESTING The appliance must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 ps...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION Conversion Kit from Natural Gas to Propane Model #431-969 for P33-3 using SIT 820 NOVA Gas Valve Remove the 2 screws, push Burner Assembly to the left and lift out. 7) Unscrew the pilot orifi ce with the allen key and replace with th...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION Note: The logs must not be in the unit. 3) Insert the back brick panel by carefully slip- ping it between the back wall of the fi rebox and the rear log bracket. OPTIONAL BRICK PANELS 1) Undo the bottom 2 door latches and open and re...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Diagram 1 Diagram 3 STANDARD FLUSH DOOR The standard fl ush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1. Be care-ful that the glass g...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace OPTIONAL BAY DOOR The Bay louvers MUST be used with the Bay glass option. The optional Bay door is an overlay on the fl ush front. The standard fl ush door and glass must remain on the unit. 1) Hook the top of the bay door over the fl ush door fl an...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace 6) Open the bottom louver. Pull the Burner ON/OFF control box from inside the bottom of the fi replace and position the slots in the bracket over the 2 screws on the left side of the bottom louver. Push down to lock into place. Tighten the screws...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace FULL SCREEN FRONT INSTALLATION 1) Before beginning the installation, remove the Glass Door from the unit. Refer to the manual for instructions. 2) Slide the Bottom Face Plate Bracket into the bottom of the unit, secure it into the pins located o...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace OPTIONAL WALL THERMOSTAT A wall thermostat may be installed if desired, connect the wires as per the wiring diagram. Use table below to determine the maximum wire length. Note: Preferable if the thermostat is installed on an interior wall. Regen...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges. WIRING DIAGRAM This heater does not require a 120V A.C. supply for operation. In case of a power failure, the burner switch and the optional...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace INSTALLATION INSTALLING THE OPTIONAL FAN 120 Volt AC power is needed for the fan switch and blower. The fan can be hard wired if desired. The receptacle box should be installed on the left hand side of the unit by a qualifi ed electri-cian. The n...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace OPERATING INSTRUCTIONS COPY OF THE LIGHTING PLATE INSTRUCTIONS

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace AERATION ADJUSTMENT The air shutter can be adjusted by moving the adjusting wire up or down. The wire is accessed through the bottom louver opening. Open the air shutter for a blue fl ame or close for a yellower fl ame. The burner aeration is fact...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace MAINTENANCE MAINTENANCE INSTRUCTIONS 1) Always turn off the gas valve before cleaning. For relighting, refer to lighting instructions. Keep the burner and control compartment clean by brushing and vacuuming at least once a year. When cleaning th...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace MAINTENANCE THERMOPILE/ THERMOCOUPLE 1) Open the bottom louvers. 2) Loosen the thermocouple or thermopile with a 7/16" wrench. 3) Disconnect thermocouple by loosening nut from the valve with a 9mm wrench. Dis-connect thermopile by loosening ...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace 10) Undo the pilot tube from the valve with a 7/16" wrench. REMOVING VALVE 1) Shut off the gas supply. 2) Remove the louvers (and bay door if it is on). 3) Open the fl ush door and remove the door. 4) Remove the logs. 5) Remove the burner/gra...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace PARTS LIST Main Assembly Part # Description Part # Description Part # Description 1) 948-247 Door Handle 2) * Thermodisc Bracket 7) 910-428 Duplex Receptacle 8) 910-429 Box - Receptacle 9) 910-430 Cover - Receptacle 10) 904-687 Clamp Connector 1...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Burner & Log Assembly Part Description 53) 430-055 Gasket - Valve Access Plate - NG/LP 54) 910-421 Pilot ON/OFF Extension Knob 55) 910-422 Flame HI/LOW Extension Knob 56) 910-190 Piezo Ignitor and Nut 433-574/P Valve Assy - Natural Gas 433-5...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace PARTS LIST Flush Front & Louvers Part # Description Part # Description 117) 904-196 Magnet - 1' round 130) 430-924 Flush Glass Trim (set) - Gold (Option) 131) 430-926 Flush Glass Trim (set) - Brass (Option) 430-947 Flush Glass Trim (set) - B...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace 430-930 Bay Front Complete 106) 940-079/P Side Glass 107) 936-243 Glass Gasket 108) 940-078/P Center Glass 110) * Bay Door Frame 111) 902-322 Bay Brick Panel - Standard 432-905 Bay Brick Panel - Standard Brown 432-906 Bay Brick Panel - Standard ...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace ___________________________________________________ ___________________________________________________ ___________________________________________________ ___________________________________________________ _____________________________________...

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace WARRANTY Regency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our facility. FPI Fireplace Products Internationa...

Installer: Please complete the following information Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Installer: ___________________________________________________________ Phone #: _________________________...