RedMax SRTZ2460F - Manuals - manualsarea.com

Page 2 - WARNING

US-1 SRTZ2460F U S 115 37 30-10 (003) OWNER 'S/ OPERATOR'SMANUAL SHORT REACH TRIMMER SRTZ2460F WARNING The engine exhaust from thisproduct contains chemicalsknown to the State of California tocause cancer, birth defects orother reproductive harm. WARNING Before using our products,please read this ma...

Page 3 - SAFETY FIRST; symbol; NOTE; Contents; Thank you for choosing our product.

US-2 SRTZ2460F SAFETY FIRST Instructions contained in warnings withinthis manual marked with a symbol concern critical points which must betaken into consideration to preventpossible serious bodily injury, and for thisreason you are requested to read all suchinstructions carefully and follow themwit...

Page 5 - Warning labels on the machine; FUEL TANK CAP; Symbols on the machine; EMISSION CONTROL INFORMATION; EMISSION CONTROL; An emission control label is located on the engine.

US-4 SRTZ2460F 3. Warning labels on the machine For safe operation and maintenance, symbolsare carved in relief on the machine. Accordingto these indications, please be careful not totake a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction to close ...

Page 6 - For safe operation

US-5 SRTZ2460F U S • A brushcutter or trimmer can be dangerous if used incorrectly orcarelessly, and can cause serious orfatal injury to the operater or others. Itis extremely important that you readand understand the contents of thisOwner's manual. • Under no circumstances may the design of the mac...

Page 7 - Using the product; IMPORTANT

US-6 SRTZ2460F contain dangerous carbon monoxide. 10. Never to touch the spark plug or plug cord while the engine is in operation Doing somay result in being subjected to anelectrical shock. 11.Never to touch the muffler, spark plug, other metallic parts of the engine orengine cover while the engine...

Page 8 - Storage; Maintenance

US-7 SRTZ2460F U S 5. For safe operation is mixed, poured, or stored. 3. Do not smoke while handling fuel or while operating the product. 4. Do not refuel a hot engine.5. Do not refuel a running engine.6. Keep the handles dry, clean and free of oil or fuel mixture. 7. Always store fuel in an approve...

Page 9 - BALANCE UNIT

US-8 SRTZ2460F 6. Set up ■ MOUNTING ENGINE (SE1) 1. Push the driveshaft housing toward the clutch housing and rotate it by hand tocheck that the driveshaft is engagedwith the gears. 2. Insert the driveshaft housing into the clutch housing until it bottoms, andalign the positioning holes on the clutc...

Page 13 - • Falling branches may fall onto the

US-12 SRTZ2460F 8. Operation following instructions when usingyour trimmer. • Never hold the trimmer in a way in which the blades are pointedtowards someone else. • Never allow the blades to come into proximity with your body while theengine of the trimmer is in operation. • Always be sure to turn o...

Page 14 - QUICK TIP; ENGINE

US-13 SRTZ2460F U S MA1 (1) MA2 9. Maintenance ■ BLADES (MA1) • When refilling the tank or resting, it is often a good idea to use the time to oilthe cutting blades. • If a gap exists between the upper and lower blades, follow the procedurebelow to adjust them so that they fitmore closely together. ...

Page 17 - Troubleshooting guide

US-16 SRTZ2460F 12. Troubleshooting guide Case 1. Starting failure CHECK PROBABLE CAUSES ACTION fuel tank ➞ incorrect fuel ➞ drain it and with correct fuel fuel filter ➞ fuel filter is clogged ➞ clean carburetor adjustment screw ➞ out of normal range ➞ adjust to normal range sparking (no spark) ➞ sp...

Page 18 - Repair or replacement of any warranted part under the warranty

US-17 SRTZ2460F U S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), EnvironmentCanada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and latersmall off-road engine. In U.S. and Canada, new equipment that use small off-roa...

Page 19 - by a failure under warranty of any warranted part.

US-18 SRTZ2460F warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regularinspection in the maintenance schedule will be warranted for a period of two years. A statement in such writteninstructions to the effect of "repair or replace as necessa...