RedMax PSZ2450S - Manuals - manualsarea.com

Page 2 - Contents; SAFETY FIRST; symbol concern critical; NOTE

US-2 PSZ2450S 1. Parts location ......................................................................32. Specifications .....................................................................33. Warning labels on the machine ..........................................44. Symbols on the machine ..........

Page 4 - WARNING; EMISSION CONTROL INFORMATION; EMISSION CONTROL

US-4 PSZ2450S 3. Warning labels on the machine For safe operation and maintenance, symbols arecarved in relief on the machine. According to theseindications, please be careful not to take a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction to close ...

Page 5 - For safe operation

US-5 PSZ2450S U S 1. Read this manual carefully until you completely understand and follow allsafety and operating instructions. 2. Keep this manual handy so that you may refer to it later whenever anyquestions arise. Also note, if you haveany questions which cannot beanswered herein, contact the de...

Page 7 - HANDLING FUEL

US-7 PSZ2450S U S 5. For safe operation have been certified by RedMax for usewith the RedMax product . 4. In the event that any part must be replaced or any maintenance or repair work notdescribed in this manual must beperformed, please contact a representativefrom the store nearest RedMax authorize...

Page 8 - • Never use a cracked or warped guide; • Do not make unauthorized modifications or; IMPORTANT

US-8 PSZ2450S 5. For safe operation • Never use a cracked or warped guide bar: replace it with a serviceable oneand make sure it fits properly. • If a saw blade should bind fast in a cut, shut off the engine immediately. Pushthe branch or tree to ease the bind andfree the blade. • Do not operate the...

Page 10 - Fuel and Chain Oil

US-10 PSZ2450S 7. Fuel and Chain Oil ■ FUEL • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine andallow it cool before refueling the unit. Select outdoor bareground for fueling and move at least 10 ft (3 m) away fromthe fueling point b...

Page 12 - STARTING ENGINE; CHECKING OIL SUPPLY

US-12 PSZ2450S 8. Operation ■ STARTING ENGINE The cutting head will start rotatingupon the engine starts. 1. Feed fuel and chain oil into their respective tanks and tighten the capssecurely. (OP1) (1) Fuel (2) Chain oil 2. Rest the unit on a flat, firm place. Keep the cutting head off the ground and...

Page 13 - ADJUSTING THROTTLE CABLE

US-13 PSZ2450S U S ■ ADJUSTING OIL FLOW RATE Never fill the oil reservoir nor adjustthe oiler with the engine running. An increase in bar oil flow rate will speedoil consumption, requiring more frequentchecks on the oil reservoir. To ensuresufficient lubrication, It may be necessaryto check the oil ...

Page 14 - MAINTENANCE CHART

Maintenance, replacement, or repair of the emission control device and systems may be performed by anynon-road engine repair establishment or individual. US-14 PSZ2450S ■ OILING PORT Dismount the guide bar and check theoiling port for clogging. (MA1) (1) Oiling port ■ GUIDE BAR Remove sawdust in the...

Page 16 - • Check the intake air cooling vent and

US-16 PSZ2450S 9. Maintenance MA15 (1) (2) MA14 TIGHTENING TORQUE: 87–121 (in-lbs) (9.8–13.7 N.m.) ■ MUFFLER • Inspect periodically, the muffler for loose fasteners, any damage orcorrosion. If any sign of exhaustleakage is found, stop using themachine and have it repairedimmediately. • Note that fai...

Page 17 - Troubleshooting guide

US-17 PSZ2450S U S Case 1. Starting failure CHECK PROBABLE CAUSES ACTION fuel tank ➞ incorrect fuel ➞ drain it and with correct fuel fuel filter ➞ fuel filter is clogged ➞ clean carburetor adjustment screw ➞ out of normal range ➞ adjust to normal range sparking (no spark) ➞ spark plug is fouled/wet ...

Page 18 - Repair or replacement of any warranted part under the warranty

US-18 PSZ2450S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), EnvironmentCanada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and latersmall off-road engine. In U.S. and Canada, new equipment that use small off-road eng...

Page 19 - by a failure under warranty of any warranted part.

US-19 PSZ2450S U S warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regularinspection in the maintenance schedule will be warranted for a period of two years. A statement in such writteninstructions to the effect of "repair or replace as nece...