RedMax HEZ2460S - Manuals - manualsarea.com

Page 2 - SAFETY FIRST; symbol; NOTE; Contents; WARNING

US-2 HEZ2460S/HEZ3060S SAFETY FIRST Instructions contained in warnings withinthis manual marked with a symbol c o n c e r n c r i t i c a l p o i n t s w h i c h m u s t b et a k e n i n t o c o n s i d e r a t i o n t o p r e v e n tpossible serious bodily injury, and for thisreason you are request...

Page 4 - Warning labels on the machine; FUEL TANK CAP; Symbols on the machine; EMISSION CONTROL INFORMATION; EMISSION CONTROL INFORMATION; An emission control label is located on the engine.

US-4 HEZ2460S/HEZ3060S 3. Warning labels on the machine For safe operation and maintenance, symbols arecarved in relief on the machine. According to theseindications, please be careful not to take a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction ...

Page 5 - For safe operation

US-5 HEZ2460S/HEZ3060S U S • A brushcutter or trimmer can be dangerous if used incorrectly orcarelessly, and can cause serious orfatal injury to the operater or others. Itis extremely important that you readand understand the contents of thisOwner's manual. • Under no circumstances may the design of...

Page 6 - Using the product; IMPORTANT

US-6 HEZ2460S/HEZ3060S contain dangerous carbon monoxide. 10. Never to touch the spark plug or plug cord while the engine is in operation Doing somay result in being subjected to anelectrical shock. 11.Never to touch the muffler, spark plug, other metallic parts of the engine orengine cover while th...

Page 8 - In the event that any part must be replaced; Disposal

US-8 HEZ2460S/HEZ3060S 5. For safe operation lubricant, always be sure to use onlyRedMax products or products which havebeen certified by RedMax for use with theRedMax product. 5. In the event that any part must be replaced or any maintenance or repair work notdescribed in this manual must beperform...

Page 9 - MOUNTING OTHER PARTS; Insert the driveshaft into the clutch

(B) (A) US-9 HEZ2460S/HEZ3060S U S 6. Set up ■ MOUNTING OTHER PARTS 1. Insert the driveshaft into the clutch drum, then attach the gearbox to theshaft tube as aligning the positioningholes and fasten the screw (A). Fastenthe clamp bolt (B) firmly. (SE1) (A) Screw(B) Clamp bolt (B) Tightning Torque: ...

Page 12 - STARTING ENGINE

US-12 HEZ2460S/HEZ3060S 8. Operation The RedMax stick edgers are designedfor edging lawn in gardens, parks,roadsides and so on. Before starting the engine, take theoperating position and adjust the handleposition and the wheel height asnecessary. ■ ADJUSTING WHEEL HEIGHT 1. Loosen the wing nut and c...

Page 13 - ADJUSTING THROTTLE CABLE; HOW TO USE

US-13 HEZ2460S/HEZ3060S U S 1. When restarting the engine immediately after stopping it, leave thechoke open. 2. Overchoking can make the engine hard to start due to excess fuel. When theengine failed to start after severalattempts, open the choke and repeatpulling the rope, or remove the sparkplug ...

Page 14 - certified by RedMax for use with the RedMax stick edger.; BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER; MAINTENANCE CHART

Maintenance, replacement, or repair of the emission control device and systems may be performed by anynon-road engine repair establishment or individual. • Always be sure to stop the engine before inspecting the stick edger for problems or performing maintenance. • Never alter the stick edger or tak...

Page 16 - • Attention to the direction of the; holder; • Check the intake air cooling vent and; PROTECTOR; • When you replace protector, use new

US-16 HEZ2460S/HEZ3060S 9. Maintenance MA9 (1) (2) MA8 (1) (2) MA7 ■ BLADE (MA6) • Place the blade between holders (A) and (B) while locking the gear shaft byputting the bar, through the key holeson the holder (A) and the gearcase.Use the socket to tighten the blademounting bolt. (1) Blade mounting ...

Page 17 - Troubleshooting guide

US-17 HEZ2460S/HEZ3060S U S Case 1. Starting failure CHECK PROBABLE CAUSES ACTION fuel tank ➞ incorrect fuel ➞ drain it and with correct fuel fuel filter ➞ fuel filter is clogged ➞ clean carburetor adjustment screw ➞ out of normal range ➞ adjust to normal range sparking (no spark) ➞ spark plug is fo...

Page 18 - Repair or replacement of any warranted part under the warranty

US-18 HEZ2460S/HEZ3060S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), EnvironmentCanada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and latersmall off-road engine. In U.S. and Canada, new equipment that use small off...

Page 19 - by a failure under warranty of any warranted part.

US-19 HEZ2460S/HEZ3060S U S warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regularinspection in the maintenance schedule will be warranted for a period of two years. A statement in such writteninstructions to the effect of "repair or replac...