Page 2 - SAFETY FIRST; symbol on the; NOTE; Contents; WARNING
US-2 HBZ2610 SAFETY FIRST Instructions contained in warnings within this manualand warning seals marked with a symbol on the blower concern critical points which must be taken intoconsideration to prevent possible serious bodily injury,and for this reason you are requested to read all suchinstructio...
Page 3 - Specifications are subject to change without notice.
US-3 HBZ2610 U S 1. Parts location ■ MODEL HBZ2610 Dimensions (L x W x H) mm (in) ···············································································327x269x360 (12.9x10.6x14.2)Dry Weight kg (lbs) ···························································································...
Page 4 - Warning labels on the machine; Fuel tank cap; Stay a safe distance from the machine.; Symbols on the machine; EMISSION CONTROL; An emission control label is located on the machine.; COMPLIANCE PERIOD : 300 HOURS; EMISSION CONTROL INFORMATION
US-4 HBZ2610 3. Warning labels on the machine For safe operation and maintenance, symbolsare carved in relief on the machine. Accordingto these indications, please be careful not tomake a mistake. (a) The port to refuel the "MIX GASOLINE" Position: Fuel tank cap (b) The direction to close th...
Page 5 - For safe operation; Before use
US-5 HBZ2610 U S • The blower is used for blowing away leaves and other debris on the ground.When operating the blower, theoperater must stand with both feetfirmly on the ground. Do not operate the blower whilestanding on a ladder or a stand. • Under no circumstances may the design of the machine be...
Page 6 - IMPORTANT
2. Never use the blower without the screen at the air intake of the blower.Before each use, check that, the screw(1) is securely tightened and is freefrom any damage. 3. Check the work area that the blower will be used in and remove or cover all valuablesthat may be damaged by the air blast orthrown...
Page 7 - For protecting your body from vibration; Disposal
US-7 HBZ2610 U S 5. For safe operation filters. ■ For protecting your body from vibration Prolonged use of a blower, exposing theoperater to vibrations and cold mayproduce whitefinger disease (Raynaud'sphenomenon), which symptoms aretingling and burning sensations followedby loss of color and numbne...
Page 8 - BLOWER PIPE; • Align groove in blower pipe with; INSTALLING SUPPORT HANDLE; • Be sure to tighten the screws straightly.
US-8 HBZ2610 6. Set up ■ BLOWER PIPE • Align groove in blower pipe with projection on blower housing (oranother blower pipe) and slide the pipeonto the blower housing (or anotherblower pipe).Rotate the pipe clockwise to lock it intoplace. ■ INSTALLING SUPPORT HANDLE • This handle is supplied with th...
Page 11 - ADJUSTING IDLE SPEED; STARTING ENGINE
US-11 HBZ2610 U S Except for an emergency, avoid stoppingthe engine while pulling the throttletrigger. ■ ADJUSTING IDLE SPEED 1. When the engine tends to stop frequently at an idle mode, turn theadjusting screw clockwise. (1) Idle adjusting screw (2) Cable adjuster Warm up the engine before adjustin...
Page 12 - AIR CLEANER
US-12 HBZ2610 every every every 25 50 100 system/compornent procedure before hours hours hours note use after after after fuel leaks, fuel spillage wipe out ✔ fuel tank, air filter, fuel filter inspect/clean ✔ ✔ replace, if necessary see ■ ADJUSTING replace carburetor idle adjusting screw ✔ IDLING S...
Page 14 - BEFORE STORING THE BLOWER:; Optional vacuum kit usage
US-14 HBZ2610 BEFORE STORING THE BLOWER: 1. Drain a fuel tank and push the primer bulb until it becomes empty of fuel. 2 .Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider.Crank the engine several time andinstall the spark plug. 3. Store unit in a dry, dust free place, out of...
Page 15 - Repair or replacement of any warranted part under the warranty
US-15 HBZ2610 U S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), EnvironmentCanada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and latersmall off-road engine. In U.S. and Canada, new equipment that use small off-road ...
Page 16 - by a failure under warranty of any warranted part.
US-16 HBZ2610 warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regularinspection in the maintenance schedule will be warranted for a period of two years. A statement in such writteninstructions to the effect of "repair or replace as necessary...