RedMax G310TS - Manuals

❲ 7 ❳ 4. For safe operation 16. O p e r a t e t h e c h a i n s a w o n l y i n w e l l ventilated areas. Never start or run theengine inside a closed room or building.E x h a u s t f u m e s c o n t a i n d a n g e r o u scarbon monoxide. 17. Do not operate a chain saw in a tree unless specially tr...

A standard saw unit package contains the items asshown. (SE1)Open the box and install the guide bar and the sawchain to the power unit as follows. The saw chain has very sharp edges. Use thick,protective gloves to avoid injury. 1. Loosen a nut and remove the chain cover. 2. M o u n t t h e g u i d e...

6. Fuel and chain oil ❲ 9 ❳ ■ FUEL The RedMax engines are lubricated by oil speciallyformulated for air-cooled 2-cycle gasoline engineuse. If RedMax oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. RECOMMENDED MIXING RATIO GASOLINE 32 :...

6. Fuel and Chain oil ■ CHAIN OIL Use motor oil SAE 10W-30 all year round, or SAE30-40 in summer and SAE 20 in winter. Do not use waste or regenerated oil that can causedamage to the oil pump. NOTE ❲ 10 ❳

■ FUELING THE UNIT (OP1) 1. Remove the fuel tank cap and pour fuel into the tank up to 80% of full capacity. 2. Fasten the fuel cap securely and wipe up any fuel spillage around the unit. 3. Remove the oil tank cap and pour chain oil into the tank. Fasten the cap securely. 1. Select bare ground for ...

❲ 12 ❳ OP8 7. Operation ■ CHECKING OIL SUPPLY After starting the engine, run the chain at mediumspeed and see if chain oil is scattered off as shownin the figure. (OP6) The oil tank should become nearly empty by thetime fuel in the tank is used up. Be sure to refill theoil tank every time when refue...

so that saw chain does not turn. If idling speed istoo slow, turn the screw clockwise. (OP8) 4. Make a test cut adjust the H needle for best cutting power, not for maximum speed. (OP8) ■ CHAIN BRAKE The chain brake is a device designed to stop thesaw chain quickly when kickback occured. The brake sy...

• Before proceeding to your job, read “For Safe Operation” section. It is recommended to firstpractice sawing easy logs. This also helps youget accustomed to your unit. • It is not necessary to force the saw into the cut. A p p l y o n l y l i g h t p r e s s u r e w h i l e r u n n i n g t h eengin...

❲ 17 ❳ 9. Maintenance Make sure to stop the engine before inspectingand/or servicing the unit. ■ DAILY MAINTENANCE SAW CHAIN It is one of the essential factors for smooth andsafe operation to keep the cutters always in goodcondition. It’s time to reform the cutters when; 1. Sawdust has become powder...

anything wrong be found, make sure to have itrepaired before next usage. ■ MONTHLY MAINTENANCE FUEL FILTER When the engine runs short of fuel supply, checkthe fuel filter for blockage. (MA9) OIL STRAINER D r a i n t h e o i l t a n k a n d r e m o v e t h e o i l s t r a i n e rlocated near the spar...

❲ 20 ❳ SPARK ARRESTER R e d M a x e n g i n e s a r e e q u i p p e d w i t h a s p a r karresting screen at the exhaust port. Periodicallycheck and keep it in good condition. In the State ofCalifornia it is required by law (Section 4442 of theCalifornia Public Resources Code) to have a sparkarreste...

❲ 21 ❳ 11. Parts list NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company. 3. When placing parts orders for ...

THE CALIFORNIA AIR RESOURCES BOARD AND KOMATSU ZENOAH Co. ARE PLEASED TO EXPLAIN THE EMISSION CONTROL SYSTEM WARRANTY ON YOUR 1995 AND LATER LAWN AND G A R D E N E Q U I P M E N T E N G I N E . I N C A L I F O R N I A , N E W U T I L I T Y A N D L A W N A N D G A R D E N EQUIPMENT ENGINES MUST BE DE...

EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE MODEL G310TS UNIT, KOMATSU ZENOAH AMERICA INC. (THE COMPANY), THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVE...