RedMax EBZ3050RH - Manuals - manualsarea.com

Page 2 - SAFETY FIRST; symbol on the; NOTE; Contents; WARNING

US-2 EBZ3050RH SAFETY FIRST Instructions contained in warnings within this manualand warning seals marked with a symbol on the blower concern critical points which must be taken intoconsideration to prevent possible serious bodily injury,and for this reason you are requested to read all suchinstruct...

Page 3 - Specifications are subject to change without notice.

US-3 EBZ3050RH U S 1. Parts location ■ MODEL EBZ3050RH Dimensions (L x W x H) mm (in) ···············································································313x394x420 (12.3x15.5x16.5)Dry Weight kg (lbs) ·······················································································...

Page 4 - Symbols on the machine; COMPLIANCE PERIOD : 300 HOURS; EMISSION CONTROL INFORMATION; Warning labels on the machine; Stay a safe distance from the machine.; EMISSION CONTROL; An emission control label is located on the machine.

US-4 EBZ3050RH For safe operation and maintenance, symbolsare carved in relief on the machine. Accordingto these indications, please be careful not tomake a mistake. (a) The port to refuel the "MIX GASOLINE" Position: Fuel tank cap (b) The direction to close the choke Position: Air cleaner b...

Page 5 - For safe operation; Before use

US-5 EBZ3050RH U S • The blower is used for blowing away leaves and other debris on the ground.When operating the blower, theoperater must stand with both feetfirmly on the ground. Do not operate the blower whilestanding on a ladder or a stand. • Under no circumstances may the design of the machine ...

Page 7 - For protecting your body from vibration; Disposal

US-7 EBZ3050RH U S 5. For safe operation ordinances. 2. To reduce sound levels, limit the number of pieces of equipment used at any one time. 3. Operate power blowers at the lowest possible throttle speed to do the job. 4. Check your equipment before operation, especially the muffler, air intakes an...

Page 11 - IMPORTANT; • The idling speed is set for 3000 rpm at

US-11 EBZ3050RH U S 8. Operation ■ STARTING ENGINE • Avoid operating the blower with the flexible tube and swivel jointdisconnected. That will reduce thecooling air and the engine could bedamaged by overheating. 1. Push the primer bulb until fuel flows out in the clear tube. (F6) (1) Primer Bulb 2. ...

Page 12 - SPARK PLUG

US-12 EBZ3050RH Maintenance, replacement, or repair of the emission control device andsystems may be performed by any non-road engine repair establishment orindividual. 9. Maintenance Make sure that the engine has stoppedand is cool before performing anyservice to the blower. Contact withrotating bl...

Page 14 - BEFORE STORING THE BLOWER:; Drain a fuel tank and push the primer; Troubleshooting guide

US-14 EBZ3050RH BEFORE STORING THE BLOWER: 1. Drain a fuel tank and push the primer bulb until it becomes empty of fuel. 2 .Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider.Crank the engine several time andinstall the spark plug. 3. Store unit in a dry, dust free place, out ...

Page 15 - Repair or replacement of any warranted part under the warranty

US-15 EBZ3050RH U S The EPA (U.S. Environmental Protection Agency), CARB (California Air Resources Board), EnvironmentCanada and RedMax are pleased to explain the emissions control system's warranty on your 2009 and latersmall off-road engine. In U.S. and Canada, new equipment that use small off-roa...

Page 16 - by a failure under warranty of any warranted part.

US-16 EBZ3050RH warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regularinspection in the maintenance schedule will be warranted for a period of two years. A statement in such writteninstructions to the effect of "repair or replace as necessa...