RedMax BCZ3050S - Manuals - manualsarea.com

Page 2 - SAFETY FIRST; symbol; NOTE; Contents; WARNING

US-2 BCZ3050S/T/SW SAFETY FIRST Instructions contained in warnings withinthis manual marked with a symbol c o n c e r n c r i t i c a l p o i n t s w h i c h m u s t b et a k e n i n t o c o n s i d e r a t i o n t o p r e v e n tpossible serious bodily injury, and for thisreason you are requested t...

Page 4 - Warning labels on the machine; FUEL TANK CAP; Symbols on the machine; EMISSION CONTROL INFORMATION; EMISSION CONTROL; An emission control label is located on the engine.

US-4 BCZ3050S/T/SW 3. Warning labels on the machine For safe operation and maintenance, symbols arecarved in relief on the machine. According to theseindications, please be careful not to take a mistake. (a) The port to refuel the "MIX GASOLINE" Position: FUEL TANK CAP (b) The direction to c...

Page 5 - For safe operation

US-5 BCZ3050S/T/SW U S • A brushcutter or trimmer can be dangerous if used incorrectly orcarelessly, and can cause serious orfatal injury to the operater or others. Itis extremely important that you readand understand the contents of thisOwner's manual. • Under no circumstances may the design of the...

Page 6 - Using the product; IMPORTANT

US-6 BCZ3050S/T/SW contain dangerous carbon monoxide. 10. Never to touch the spark plug or plug cord while the engine is in operation Doing somay result in being subjected to anelectrical shock. 11.Never to touch the muffler, spark plug, other metallic parts of the engine orengine cover while the en...

Page 8 - When replacing the any other part, or any; Disposal

US-8 BCZ3050S/T/SW 5. For safe operation muffler, and the ignition wiring. 4. When replacing the any other part, or any lubricant, always be sure to use onlyRedMax products or products which havebeen certified by RedMax for use with theRedMax product. 5. In the event that any part must be replaced o...

Page 12 - STARTING ENGINE; ADJUSTING THROTTLE CABLE

US-12 BCZ3050S/T/SW 8. Operation ■ STARTING ENGINE The cutting head will start rotatingupon the engine starts. 1. Rest the unit on a flat, firm place. Keep the cutting head off the ground andclear of surrounding objects as it willstart rotating upon starting of theengine. 2. Push the primer pump sev...

Page 14 - MAINTENANCE CHART

US-14 BCZ3050S/T/SW every every every 25 50 100 system/compornent procedure before hours hours hours note use after after after fuel leaks, fuel spillage wipe out ✔ fuel tank, air filter, fuel filter inspect/clean ✔ ✔ replace, if necessary see ■ ADJUSTING replace carburetor idle adjusting screw ✔ ID...

Page 17 - CHOOSE THE BLADE; have been certified by RedMax.; SET UP THE BLADE

US-17 BCZ3050S/T/SW U S • When sharpening, removing, or reattaching the blade, be sure to wear thick, sturdy gloves and use only proper toolsand equipment to prevent injury. ■ CHOOSE THE BLADE Choose a suitable recommended cutting attachment according tothe object to be cut. (OPT3)• When replacing b...

Page 20 - Troubleshooting guide

US-20 BCZ3050S/T/SW Case 1. Starting failure CHECK PROBABLE CAUSES ACTION fuel tank ➞ incorrect fuel ➞ drain it and with correct fuel fuel filter ➞ fuel filter is clogged ➞ clean carburetor adjustment screw ➞ out of normal range ➞ adjust to normal range sparking (no spark) ➞ spark plug is fouled/wet...

Page 21 - FEDERAL AND CALIFORNIA EMISSIONS CONTROL WARRANTY

US-21 BCZ3050S/T/SW U S The EPA (U.S. Environmental Protection Agency), CARB (CaliforniaAir Resources Board), Environment Canada and RedMax arepleased to explain the emissions control system's warranty on your2009 and later small off-road engine. In U.S. and Canada, newequipment that use small off-r...

Page 22 - RedMax; U S

RedMax STANDARD LIMITED WARRANTY STATEMENT ALL Products Sold on or after 1/01/2009 All RedMax Brand Products RedMax Limited Warranty, provides to the ORIGINAL retail purchaser that this RedMax product is free from DEFECTS in MATERIAL and WORKMANSHIP under normal use and maintenance from the date of ...