Page 2 - Contents; Before You Start; Problems; General Information
Due to our policy of continual improvement, we reserve the right to change specifications without prior notice. Contents 1. Before You Start 1 At Time of Delivery 1 During Installation 1 During Normal Use 1 If a Fault Occurs 1 Caring for the Environment 1 2. Overview and Operation 2 Getting to Know ...
Page 3 - Disposing of your packaging
1 1. Before You Start At Time of Delivery Check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged DO NOT USE. Contact your supplier or customer services.Please dispose of packaging materials properly. During Installation • Site the dishwasher and connect...
Page 4 - Getting to Know Your Dishwasher; Dishwasher Interior; Overview and Operation
2 Getting to Know Your Dishwasher Dishwasher Interior (Fig.2-1) Control Panel (Fig.2-2) 2. Overview and Operation B J A E I C H L D G K F A Upper rack B Upper spray arm C Lower rack D Cutlery basket E Control panel F Lower spray arm G Salt container cap H Washing filter I Detergent and rinse aid dis...
Page 5 - Salt; Loading the salt into the container; To prevent the formation of rust, load the salt; Adjusting salt consumption
3 Salt The hardness of water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils.The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the salt int...
Page 6 - Rinse Aid; Loading the rinse aid; Proper dosage of rinse aid improves drying.; Detergent; Loading the detergent; sure you select the combination detergent tablet
4 ArtNo.800-207 - Dispenser - Removing the rinse aid cap Rinse Aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door.When the low rinse aid indicator on the control panel (Fig.2-5) and the indicator on the dispenser (Fi...
Page 7 - Dishes or cutlery that have been soiled by; Damage to Glassware and Other Dishes; Possible causes
5 A B What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood. They become faded and unsightly in appearance. Furthermore the adhesives that are used are not suitable for the temperature that occurs inside the dishwasher.Delicate decorative glassware...
Page 8 - Dishwasher; Using the lower rack; Knives and other utensils with sharp points must; Using the upper rack
6 Arranging Crockery, Glasses, etc. in the Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, resulting in reduced performance.If the pots and pans have baked-on food that is extremely hard to remove, we recommend that th...
Page 9 - Washing Dishes
7 ArtNo.800-0304 - Using the cup rack ArtNo.800-0305 - Knife rack Fig.2-15 Fig.2-16 Washing Dishes Programme overview Time delayPress for additional options (scroll through): Upper rack wash functionLower rack wash functionCombi detergent tablets function Program selectStart/reset button Programme s...
Page 11 - There is a risk of water coming out from inside the; Cancelling or modifying a cycle; Using 3-in 1 Detergent Tablets; General Advice
9 Switching the dishwasher OFF Several minutes after the programme has ended: 1. Open the door. 2. Set the ON-OFF button to OFF. 3. Remove dishes, etc. when they have cooled down. Note: For the best drying performance, we recommend that you do not remove the contents for at least 30 minutes. This al...
Page 12 - Upper rack wash; To cancel the upper rack wash:; Lower rack wash; To cancel the lower rack wash:
10 Start/reset button To select the ‘tablets’ function: 1. Open the door. 2. Select the programme and then press the additional options button (Fig.2-20) until the tablets indicator [ ] lights. 3. Press the Start/Reset button (Fig.2-21) and close the door. The dishwasher will start immediately. To c...
Page 13 - Delayed start programming; Reset drain function
11 Delayed start programming You can delay the start of a programme from 1 hour up to 24 hours. 1. Open the door, switch the dishwasher ON. 2. Press programme button to choose the desired programme. 3. Press the Delayed Start button (Fig.2-22) ; the time- remaining indicator changes to ‘1’. 4. Press...
Page 14 - Looking after your Dishwasher; Care; Before cleaning or performing maintenance isolate; Overall condition of appliance; Dishwasher salt; Refit the spray arms. Make sure that the lower arm; Solvents or Abrasive Cleaning Products
12 3. Looking after your Dishwasher Care After Every Wash After every wash, set the ON-OFF button to OFF and leave the door slightly ajar so that moisture and odours are not trapped inside. n n Before cleaning or performing maintenance isolate from mains. Overall condition of appliance Check that no...
Page 17 - Problems during washing
15 If the dishwasher still does not function and/or the problem persists, contact the nearest authorized service centre and provide them with the following information: 1. The nature of the problem. 2. The model type number (Mod...) and serial number (S/N...), as indicated on the plate located on th...
Page 18 - BEFORE; Drain Hose Connection; WARNING! The connecting piece for the siphon trap
16 ArtNo.800-0101 - Cold water connection Washer Water hose ¾“ BSP tap connector 5. Installation Positioning the Dishwasher The dishwasher should be aligned to the front of the adjacent cabinets, with allowance made for the door thickness. The dishwasher has water supply and drain hoses that can be ...
Page 19 - Electrical Connection; WARNING: THIS APPLIANCE MUST BE EARTHED; Care for the external cable; Levelling the Dishwasher
17 Electrical Connection The dishwasher must be installed by a qualified electrician, in accordance with all relevant British Standards/Codes of Practice (in particular BS 7671), or with the relevant national and local regulations. n n WARNING: THIS APPLIANCE MUST BE EARTHED All external wiring must...
Page 20 - Fitting the Decor Door; Fixing the door panel fittings
18 ArtNo.800-0106 - Fitting the door B A ArtNo.800-0111 - Marking the plate position ArtNo.800-0105 - Fitting the plastic hooks Fig.5-8 Fig.5-9 Fig.5-10 ArtNo.800-0107 - Securing the door Fig.5-11 The adjustable feet allow the dishwasher to be raised up to 870 mm. If the space between the floor and ...
Page 22 - Information on comparability tests
20 6. General Information Measures must be taken to ensure that the units that are subsequently re-sited as freestanding appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface, that is screwed to the adjacent cupboards....
Page 24 - Dimensions; Connections
22 8. Technical Data INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Inside face on the side of the door. COUNTRY OF DESTINATION: GB/IE Dimensions 550 600 580 596 820 - 880 725 max 820 All dimensions in mm Connections Electric 220-240 v 50 Hz Ratings Energy efficiency ...