Precor Ab-X100 - Manuals - manualsarea.com

Page 3 - IMPOR; Important Safety Instructions; Obtaining Service

Ab-X100 Assembly Guide page 3 IMPOR T ANT SAFETY INSTRUCTIONS Important Safety Instructions Important Safety Instructions When using exercise equipment, basic precautionsshould always be taken, including the following: • Read all instructions before assembling theAb-X100. These instructions are writ...

Page 4 - Table of Contents

Ab-X100 Assembly Guide page 4 Table of Contents 1 2 Important Safety Instructions .................................................................................. 3 Obtaining Service ......................................................................................................................

Page 5 - Preparations; Unpacking the Equipment; Installation Requirements; Review the

Ab-X100 Assembly Guide page 5 1 Preparations Preparations The Ab-X100 parts are inspected before shipment.Each unit contains several pieces that requireassembly. You may find it helpful to ask for assistanceduring the assembly process. Unpacking the Equipment When you open a box, carefully unpack th...

Page 6 - Fastener; Hardware Kit; Preparations, continued

Ab-X100 Assembly Guide page 6 ¾-inch Shoulder bolt (J) 2 Pivot arm cap (K) 2 1-inch Buttonhead screw (A) 6 ³⁄₈ -inch Washer (C) 6 ¾-inch Buttonhead screw (D) 8 ⁵⁄₁₆ -inch Washer (F) 4 Fastener Qty Fastener Qty Hardware Kit Preparations, continued ³⁄₈ -inch Split washer (B) 6 ⁵⁄₁₆ -inch Split washer ...

Page 8 - Assembly Instructions; Note; Do not fully; Open the Box

Ab-X100 Assembly Guide page 8 2 AssemblyInstructions Assembly Instructions Assembly of the Ab-X100 takes about 45 minutes tocomplete. If this is the first time you have assembledthis type of equipment, plan on allowing more time. Be careful to open boxes and assemble components inthe sequence presen...

Page 9 - Assemble the Main Structure

Ab-X100 Assembly Guide page 9 Assemble the Main Structure 1. Insert the End Caps (M) into the Front Support andattach two plastic feet (L) to its base. Secure thepieces usingtwo 1¼-inch buttonhead screws (G)two split washers (E)Wrench tighten. 2. Set the Main Frame in an upright position. 3. Cut the...

Page 10 - Assemble the Main Structure, continued

Ab-X100 Assembly Guide page 10 Main Frame Base Support Pivot Arm Support Bar Handlebars 2 - 1" shoulderbolts 2 - pivotarm caps 6. Lift the Support Bar so you can access the PivotArm mounting holes. 7. Have your assistant angle the HandlebarAssembly beneath the Support Bar and positionthe Pivot A...

Page 12 - Attach the Seat and Back Pad

Ab-X100 Assembly Guide page 12 Attach the Seat and Back Pad Seat Pad 4 - 1¼" buttonhead screws4 - split washers4 - flat washers Back Pad Back Pad ChannelSupport Main Frame Attach the Seat and Back Pad 1. Attach the Seat Pad to the Main Frame usingfour 1¼-inch buttonhead screws (G)four split wash...

Page 13 - Clean the Pads and Assembly

Ab-X100 Assembly Guide page 13 Clean the Pads and Assembly Clean the Pads and Assembly To clean the seat or back pads moisten a clean, softcloth in a mild solution of soap and water and wipe thepads thoroughly. Dry the pads with a clean, dry cloth. Use the same procedure to clean the Main Frame andp...

Page 14 - Limited Warranty

Effective 27 November 2006 P/N CW31973-102 page 14 Limited Warranty Precor, Incorporated (PRECOR) will repair or replace any of the following components whichare defective as to materials or workmanship for products manufactured and sold after June 1,1990: ICARIAN & STRETCH CENTER: Lifetime:Stru...

Page 16 - Ab-X100 Specifications

Precor, Icarian, and Move Beyond are registered trademarks of Precor Incorporated.Copyright 2006 Precor Incorporated.Specifications subject to change without notice. www.precor.com NOTICE : Precor is widely recognized for its innovative, award winning designs of exercise equipment. Precor aggressive...