Polaris Vac-Sweep 360- Manuals

Page 2 - Important Information; • The Polaris should not be used to remove plaster dust in new pools.; For customer service or support:; • Please mail Warranty Card immediately.; US and Canada; Customer Service; Polaris Vac-Sweep® 360 Limited Warranty

www.polarispool.com Important Information • Solar heating systems, ozone generators, and other air inducing equipment may cause air flow through the cleaner, adversely affecting cleaner balance and performance. The dedicated cleanerline must be upstream of these compenents. • Highly chlorinated wate...

Page 3 - Introduction; Polaris 360 Complete Cleaner; English

www.polarispool.com Congratulations on the purchase of your new automatic pool cleaner, and thank you forc h o o s i n g Po l a r i s. T h e Po l a r i s Va c - S we e p 3 6 0 i s d e s i g n e d t o g i ve yo u ye a r s o fdependable and efficient service. Like most mechanical devices, the Polar is...

Page 4 - Install the Universal Wall Fitting; Quick Installation Instructions

www.polarispool.com Four quick steps to install and get maximum performance from the Polaris 360: • Install the Universal Wall Fitting (UWF) with Quick Disconnect and Eyeball Regulators • Test and adjust water pressure • Adjust feed hose to fit pool length • Check for proper wheel RPM (revolutions p...

Page 6 - Buy an additional hose section and add to first hose section.

www.polarispool.com 3 Test and Adjust Water Pressure The Polaris is packaged with a pressure tester installed on the hose. Simply attach the hoseto pool wall using the Quick Disconnect fitting. Turn pump on, cover large hole with thumband confirm that water is released from the Pressure Relief Valve...

Page 8 - See Troubleshooting for other action adjustments.; Cleaning the Filter Bag; Routine Maintenance

www.polarispool.com When operating correctly, the Polaris vacuums, sweeps and scrubs all surfaces randomlythroughout the pool. The climbing ability of the Polaris depends on the pool’s shape andwater pressure or flow. The Polaris climbs best in pools without sharp angles or curves in thetransition f...

Page 9 - Exploded Parts Diagram

www.polarispool.com 1 9-100-1014 All-Purpose Bag* 1 2 9-100-1152 Housing, Turbine Upper 1 3 9-100-1114 Hub Cap 3 4 9-100-5107 E-clip, Stainless Steel 10 5 9-100-1108 Ball Bearing 8 6 C10 Tire, MaxTrax ® * 3 7 9-100-1008 Wheel, Double-side 2 8 9-100-1017 Belt Kit, Small and Large 1 9 9-100-7011 Shiel...

Page 10 - Troubleshooting

www.polarispool.com If the Polaris cleaner displays the followingactions, adjustments may be necessary torestore performance. Refer to the explodedparts diagram for part references. Action: Hangs up on steps or otherobstacles longer than 3-1/2minutes. Solution: 1. Check the wheel RPM. 2. Verify the ...

Page 11 - Troubleshooting Worksheet; Are the swivels rotating freely?

www.polarispool.com Action: Sweep hose constantly sprayswater out of the pool. Solution: 1. Adjust the speed of the sweep hose by tightening theadjustment screw. 2. Replace the sweep hose scrubber (part #9-100-3105) ifit is worn or missing. 3. Add a sweep hose weight (order part #B2) to keep theswee...