Oricom ECO710 - Manuals

3 Getting started Location You need to place the base unit within 2 metres of the mains power socket and telephone socket so that the cables will reach. Make sure it is at least 1 metre away from other electrical appliances to avoid interference. Your cordless phone works by sending radio signals be...

4 Tip! It is good practice to put the cordless handset on the charging cradle when it is not in use to ensure that the handset is always fully charged. D O N O T U S E S T A N D A R D / A L K A L I N E B A T T E R I E S I N T H I S P R O D U C T , A S THERE IS A RISK OF EXPLOSION AND/ O R I N J U R ...

5 Purchasing additional handsets You may expand your cordless system by adding more handsets (eco7150). These can be purchased separately from the retailer where you purchased the product, or directly from Oricom (Australia) www.oricom.com.au. The eco71 and eco710 can accommodate a total of 4 cordle...

PACK CONTENTS 6 Interference If the sound quality gets worse as you move around while on a call, this is probably caused by interference between the handset and the base unit, perhaps because you are too near to another phone or other electrical equipment. Move to a different position to clear the i...

PACK CONTENTS 7 Phone Function Keys The buttons in this operating manual are depicted with a uniform contour. Therefore, slight deviations in the appearance of the symbols on the telephone buttons compared to those shown here are possible. Handset 1 Earpiece 2 OK button - Select a menu entry 3 NAVIG...

8 10 END button - End a call - Press and hold to turn the handset on/off - Exit the menu/operation 11 R (Recall button) 12 Redial button - Enter redial list and dial the recent number 13 [#] button - Insert a pause. - Long press to turn the ringer on/off 14 INT button - Make an intercom call - Make ...

9 1 Answering machine /in use indicator2 Turn the answering machine on/off 3 Delete current message, long press to delete all read messages 4 Increase speaker volume 2 3 4 8 5 6 7 1 Answering machine operation (eco710 ONLY) You can use the keys on the base station to perform the basic functions of t...

11 Your Telephone Operations Switching on/off Press and hold the END button for more than 2 seconds to switch on/off the handset in standby mode.You can switch the handset off and save battery charge. To lock/unlock the keypad Press and hold the  key for 1 second to lock/unlock the keypad in standb...

13 Answer and end a call 1. When the phone rings, press TALK key. 2. To end a conversation, press END button. When the handset rings during an incoming call, please do not hold the handset too close to your ear as the volume of the ringing tone may damage your hearing. WARNING: ! I M P O R T A N T N...

15 Set time format 1. Press MENU key to enter menu selection. 2. P r e s s t h e N a v i g a t i o n k e y t o s e l e c t CLOCK&ALARM and then press OK key to select. 3. Press the Navigation key to select SET FORMAT and then press OK key to select. 4. Press O K key to enter TIME FORMAT. The cur...

16 Set alarm tone 1. Press MENU key to enter menu selection. 2. P r e s s t h e N a v i g a t i o n k e y t o s e l e c t CLOCK&ALARM and then press OK key to select. 3. Press the Navigation key to select ALARM TONE and then press OK key to select. 4. Press the Navigation key to select MELODY 1,...

17 uSING YOuR PhONEBOOK Using your phonebook Your phone can store up to 20 phonebook memories. Each phonebook entry can have a maximum of 24 digits for the phone number and 12 characters for name.How to enter characters? When you select a field in which you can enter text, you can enter the letters ...

18 uSING YOuR PhONEBOOK 3. Press the Navigation key to select DELETE and then press OK key to select. 4. Press the Navigation key to select an entry to delete and then press OK key. 5. P r e s s O K k e y a g a i n t o c o n f i r m . A confirmation beep is played. Delete all entries from the phoneb...

19 uSING YOuR PhONEBOOK uSING YOuR PhONEBOOK Add/edit direct access memory 1. Press MENU key to enter menu selection. 2. P r e s s t h e N a v i g a t i o n k e y t o s e l e c t PHONEBOOK and then press OK key to select. 3. Press the Navigation key to select DIRECT MEM. And then press OK key to sel...

20 uSING ThE REdIAL LIST Delete a redial number 1. Press REDIAL key in standby mode to go to the redial list. 2. Press the Navigation key to select an entry and then press MENU key. 3. Press the Navigation key to select DELETE and then press OK key to select. 4. Press OK key again to confirm. A conf...

21 uSING ThE REdIAL LIST uSING ThE CALL LOG Using the call log To receive Caller ID you may need to contact your telephone service provider, and they will inform you also of any charges for it. Caller ID lets you see the phone numbers of your callers on the handset display, before you answer and in ...

23 ANSWERING MAChINE OPERATION BY hANdSET (ECO710 ONLY) Record a personalized outgoing message • Y o u c a n c h o o s e t o r e p l a c e t h e p r e d e f i n e d OGM with your own pre-recorded personalized messages. 1. Press the MENU key to enter menu selection. 2. Press the Navigation key to sel...

24 Using the intercom Intercom, call transfer and conference are only possible with at least 2 handset registered to the same base station. It allows you to make free internal calls, transfer external calls from one handset to another, and set up a 3-way conference with two handsets and an external ...

25 uSING ThE INTERCOM uSING ThE INTERCOM S w i t c h b e t w e e n a n i n t e r n a l a n d external call During the call, press INT key to switch between an internal or external call. Establish a three-party conference call The conference call feature allows one external call to be shared with two...

26 AdvANCEd uSE OF YOuR TELEPhONE Register your handset IMPORTANT: When you purchase a telephone, all handsets are already registered to the base, so you do not need to register them. Handset registration is only necessary when you buy extra handsets or if a handset has become faulty.They may be dif...

27 AdvANCEd uSE OF YOuR TELEPhONE AdvANCEd uSE OF YOuR TELEPhONE WAITING is displayed on the screen. A confirmation beep is played to indicate successful registration, and the handset will return to standby mode, with its handset number displayed. • If no base is found within a certain period, NO BA...

28 AdvANCEd uSE OF YOuR TELEPhONE 2. Press the Navigation key to select ADVANCED SET and then press OK key to select. 3. Press the Navigation key to select FIRST RING and then press OK key to select. 4. Press the Navigation key to select ON or OFF and then press OK key to confirm. A confirmation bee...

29 AdvANCEd uSE OF YOuR TELEPhONE ANSWERING MAChINE SETTINGS (ECO710 ONLY) Answering machine settings (eco710 ONLY) Set ring delay 1. Press the MENU key to enter menu selection. 2. Press the Navigation key to select ANSW MACHINE and then press OK key to select. 3. P r e s s t h e N a v i g a t i o n...

31 ANSWERING MAChINE SETTINGS (ECO710 ONLY) TROuBLEShOOTING Troubleshooting ALWAYS check first that: You have followed all the steps listed in the user manual to install and set up your telephone. All connectors are firmly inserted in their sockets.Mains power to the base unit is switched on at the ...

32 • The base unit needs mains power for normal operation of the phone – not just for charging the batteries. • Make sure you are using the telephone line cable that was supplied with your "My call was cut off when I went out of range. Now I can’t use my handset."• Move the handset closer to...

34 Warranty information (Australia) Oricom makes no other warranties or conditions, express or implied, including as to acceptable quality and fitness for a particular purpose, except as stated in this Warranty. Any implied warranties that may be imposed by law are limited in duration to the Warrant...

36 Customer Support Customer Support If you have any problems setting up or using this product you will find use-full tips and information in the Troubleshooting section of this user guide as well as "Frequently Asked Questions" on our website www.oricom.com.au. If you have further questions...

Australia Oricom International Pty Ltd Locked Bag 658 South Windsor, NSW 2756 Australia Email: [email protected] Phone: 1300 889 785 (Monday to Friday 8am to 6pm AEST) Web: www.oricom.com.au Fax: (02) 4574 8898 Ref:17082011