Nutone IMA4406 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS; INSTALLATION

2 INSTALLATION TABLE OF CONTENTS INSTALLATION PAGE Contents of Carton . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Precautions and Guidelines . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 3 - WIRING SPECIFICATIONS

CONTENTS OF CARTON Check ( 3 ) for the following IMA-4406 carton contents. o IMA-4406 master station o Terminal board o Transformer cover o Hardware bag assembly containing:2 - shoulder screws12 - No. 6 x 3/8 screws4 - colored panel mounting screws4 - ‘L’ panel mounting brackets o Homeowner’s manual...

Page 5 - CONNECTING DOOR SPEAKER WIRING

5 Refer to Figure 4. If a NuTone Volume Control is installed in the system, connect the control’s IW-2 wiring to the ORN andORN/WHT screw terminals at the master station. Only ONE NuTone speaker may be connected to each volumecontrol. Each volume control/speaker counts as aremote station. Remember: ...

Page 6 - MOUNTING THE MASTER STATION; Refer to Figure 10A and 10B.

Model IA-29 Only 1. Refer to Figure 8. Locate the chime selector switch mounting bracket in the master unit. 2. Remove and set aside the chime selector switch retaining screw located in the master unit. 3. Remove and discard the square foam pads on the chime selector switch PC board connected to the...

Page 7 - The transformers’ primary leads; CAUTION; MOUNTING THE TRANSFORMER COVER; Remove the left front and right rear

7 CONNECTING THE POWER TRANSFORMERS 1. Refer to Figure 14. The transformers’ primary leads should already be connected to the 120 volt AC housesupply wiring. Be sure power is off before connecting transformers to master unit. 2. Locate the two (2) sets of red/wht transformer leads on the lower left ...

Page 8 - Refer to Figures 16 and 17.

8 INSTALLATION (Continued) FIGURE 16 FIGURE 17 CONNECTING THE MASTER STATION TOTHE TERMINAL BOARD 1. Refer to Figures 16 and 17. Plug all five connectors into the terminal board. 1. • Insert black ribbon cable with 10 pin plug into CN104 connector. 1. • Insert multi-color ribbon cable with 14 pin pl...

Page 9 - CONNECTING THE RADIO ANTENNA; AM ANTENNA

CONNECTING THE RADIO ANTENNA 1. Refer to Figure 18. Plug radio antenna (supplied with IR105 rough-in frame) into the 2-pin connector located onthe main circuit board. Be certain the tab on the connectoris facing towards the top of the master unit, as illustrated. In most locations the antenna suppli...

Page 10 - CONNECTING OPTIONAL ACCESSORIES

10 CONNECTING OPTIONAL ACCESSORIES 1. Refer to Figure 22. To connect an external audio source (NuTone Model CP-95 cassette, stereo system, VCR, TV,etc. with low level audio output) to the IMA-4406 masterstation, locate the TAPE and AUX iliary inputs on the upper center of the master station’s main c...

Page 11 - PLEASE NOTE

11 clearance hole must be drilled behind the mounting bracketbefore securing the master station panel. POWERING UP THE SYSTEM Once all connections have been completed throughout thesystem, it is time to apply power to the master station. 1. Apply power to the master station by turning on the circuit...

Page 12 - OPERATIONAL CHECKOUT; SYSTEM OPERATING CONTROLS

12 OPERATIONAL CHECKOUT SCAN: Activates scan tuning during AM/FM operation. st UP/DOWN TUNING: Provides manual tuning of the AM/FM radio. MEMORY 1-6 KEYS: Provides direct access to stored radio frequencies. TRACK : Returns to the beginning of the current track and/or previous tracks. TRACK : Advance...

Page 13 - DIGITAL CLOCK; SETTING THE TIME; SYSTEM CHECKOUT; s t; SETTING PROGRAM AUDIO CONTROLS

13 CAUTION Never touch the lens of the CD player or damagewill result! DIGITAL CLOCK SETTING THE TIME The proper clock setting procedure is arranged in 4segments. Each segment must be completed in 5 seconds.Follow the procedure below. 1. Press the TIME SET key one time. The ‘Hours’ display will begi...

Page 15 - An incorrect voltage caused

15 KEY DISPLAY KEY DISPLAY No key 1:00 Memory 2 1:14 Scan 1:01 Memory 3 1:15 s 1:02 Memory 4 1:16 t 1:03 Memory 5 1:17 Program Off 1:04 Memory 6 1:18 AM 1:05 Play/Pause 1:19 FM 1:06 RDM/RPT 1:20 Tape 1:07 Track 1:21 Aux 1:08 Track 1:22 Timer 1:09 Display 1:23 Inside/Patio 1:10 Stop 1:24 Door Talk 1:...

Page 16 - INSTALLER’S TROUBLESHOOTING GUIDE

16 TROUBLE No radio, no intercom.(No Display). No radio, intercom working. (AM/FM indicator on.) Low or distorted radiovolume. Weak and distorted music,chime and intercom audio. No electrical power. Defective transformer. Faulty Master Station. Installation problem. Antenna problem. Incorrect volume...

Page 20 - Product specifications subject to change without notice.

4820 Red Bank Road, Cincinnati, Ohio 45227 Printed in China, Rev. 06/06, Part No. 62377 Product specifications subject to change without notice.