Nortel 893-862-B - Manuals - manualsarea.com

Page 2 - Ordering Bay Networks Publications

© 1996 by Bay Networks, Inc. All rights reserved. Trademarks Bay Networks, BayStack, and Bay Networks Press are trademarks of Bay Networks, Inc. Other brand and product names are registered trademarks or trademarks of their respective holders. Statement of Conditions In the interest of improving int...

Page 3 - Introduction; Using the

893-862-B 1 Introduction This guide describes the Bay Networks 10BASE-FL (fiber link) and single-mode fiber media adapters for the BayStack 10BASE-T Hubs, and provides instructions for installing, connecting, and configuring the adapters in the hub. Each BayStack fiber media adapter provides one non...

Page 4 - BayStack 10BASE-FL Media Adapter; m multimode fiber optic cable.; TX

2 893-862-B BayStack 10BASE-FL Media Adapter The BayStack 10BASE-FL Media Adapter is a modular 10BASE-FL fiber link port. It is designed to be installed in either media adapter slot of a BayStack 10BASE-T Hub. The port is compatible with the IEEE 802.3 10BASE-FL specification for Ethernet running ov...

Page 5 - BayStack Single Mode Fiber Media Adapter; “Fiber Optic Cable Length; Single Mode Fiber; RX

893-862-B 3 BayStack Single Mode Fiber Media Adapter The BayStack Single Mode Fiber Media Adapter is a modular port supporting 10BASE-F signaling. It is designed to be installed in the media adapter slot of any BayStack 10BASE-T Hub. The port conforms to Bay Networks proprietary standards for Ethern...

Page 6 - Fiber Optic Cable Length Limitations; Table 1; Parameter

4 893-862-B Fiber Optic Cable Length Limitations The 10BASE-F standard permits you to use fiber optic cables up to 2000 meters long. However, the fiber connection must meet: • Optical power budget • Ethernet repeater rules For more information about simple rules for Ethernet network compliance, refe...

Page 8 - Table 3. Single-mode fiber optical power budget; Your fiber connection must meet the optical

6 893-862-B BayStack Single Mode Fiber Media Adapter The optical power budget for the single-mode fiber media adapter is shown in Table 1 . Power loss in the link cannot exceed the value for the type of fiber optic cable you are using. Only in-line fiber-to-fiber connections (a connection between tw...

Page 9 - Installing a Media Adapter in a BayStack Hub; To install a media adapter, follow these steps:; Unplug the BayStack 10BASE-T Hub power cord from; b. Firmly push the media adapter into the connector.

893-862-B 7 Installing a Media Adapter in a BayStack Hub A BayStack 10BASE-FL media adapter is installed in a slot on the front of the BayStack 10BASE-T Hub. To install a media adapter, follow these steps: 1. Unplug the BayStack 10BASE-T Hub power cord from the AC power source. 2. Remove the filler ...

Page 10 - Verify the installation for the media adapter.; Using the BayStack 10BASE-T Hubs; Table 4. Media adapter status LEDs

8 893-862-B 6. Verify the installation for the media adapter. Observe for the installed media adapter that the respective Media Adapter LEDs on the front panel of the hub light according to Table 4. For more information about interpreting media adapter LEDs, refer to Chapter 1, “Quick Reference Info...

Page 12 - Electromagnetic Emissions; Bay Networks Customer Support

10 893-862-B Electromagnetic Emissions Meets requirements of: FCC Part 15, Class A Digital DevicesVCCI Class 1 ITEEN 55 022 (CISPR 22, Class B)General License Vfg 243 (Class B) Compliance with the VCCI regulation is dependent upon the use of shielded AC power cables. The user is responsible for proc...