Page 2 - Thank you for purchasing the; TABLE OF CONTENTS
Thank you for purchasing the Niles R-6L or R-8L Hand-Held Learning Remote Control . With proper setup and operation, you should enjoy years of trouble-free use. Niles manufactures the industry’s most complete line of custom installation components and accessories for audio video systems. To see the ...
Page 3 - Niles R-8L Hand-Held Learning Remote Control; INTRODUCTION; The Niles
Figure 1. Niles R-8L Hand-Held Learning Remote Control NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373 INTRODUCTION The Niles R-6L and R-8L hand-held learning remote controls are used as source controllers for Niles MultiZone receivers (ZR-4 and ZR-6 respectively). They come preloaded with Z...
Page 4 - PARTS GUIDE; ) SOURCE SELECT KEYS; always appearing as source; ) CHANNEL SELECT KEYS
2 PARTS GUIDE 1) SOURCE SELECT KEYS 1.) Pressing one of these keys selects the built-in AM/FM tuner or any of the connected sources for playback and operation (for the ZR-4, up to three connected sources, SRC 2-4; and for the ZR-6/ZR-PRO up to five connected sources, SRC 2-6 with iPod ® always appear...
Page 6 - BATTERY INFORMATION; BATTERY USE AND SAFETY; CONFIGURATION; CONFIGURE A SOURCE; To configure the Niles
4 BATTERY INFORMATION Your Niles R-6L or R-8L Hand-Held Learning Remote Control requires 2 Alkaline “A A” batteries (included). BATTERY USE AND SAFETY • Use only fresh batteries of the required size and recommended type • Do not mix old and new batteries, different types of batteries (standard, alka...
Page 7 - SEARCHING FOR YOUR CODE
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373 5 4. Enter the first five-digit code for the device and brand that you wish to program. The source key LED blinks once as each digit is entered. If the code is valid, source key the LED blinks twice. NOTE: IF THE SOURCE KEY LED DOES NOT BLINK T...
Page 8 - CHECKING THE CODES; If you have set up the remote using the procedure in “; LEARNING PRECAUTIONS; Your original remote controls must be in working order to learn; PROGRAMMING A LEARNED KEY
6 CHECKING THE CODES If you have set up the remote using the procedure in “ SEARCHING FOR YOUR CODE ”, you may need to find out which five-digit code is operating your equipment. For example, to find out which code is assigned to your TV: 1. Press TV source key once 2. Press and hold SETUP until the re...
Page 9 - DELETING A SINGLE LEARNED KEY; Programming a
remote control) that you want the R-6L or R-8L Hand-Held Learning Remote Control to learn. Press the source key for which you wish to learn keys. 2. Press and hold SETUP until the source key LED blinks twice, then release. 3. Enter 9 7 5 . The source key LED blinks twice. NOTE: IF THE SOURCE KEY LED...
Page 10 - DELETING ALL LEARNED KEYS OF A SPECIFIC DEVICE; RESTORING KEY FUNCTIONS TO FACTORY SETTINGS; SETUP; PROGRAMMING SEQUENCES; Your Niles; PROGRAMMING A DEVICE INDEPENDENT SEQUENCE; SETUP
DELETING ALL LEARNED KEYS OF A SPECIFIC DEVICE NOTE: IF MORE THAN 10 SECONDS PASS BETWEEN KEY PRESSES, THE REMOTE EXITS PROGRAMMING. 1. Press and hold SETUP until the source key LED blinks twice, then release 2. Press 9 7 6 . The source key LED blinks twice 3. Press a source key twice to clear all t...
Page 11 - PROGRAMMING A DEVICE DEPENDENT SEQUENCE; TROUBLESHOOTING; LED does not blink when you press a key.
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373 9 (CONTINUED ON NEXT PAGE) PROGRAMMING A DEVICE DEPENDENT SEQUENCE 1. Press a source key.2. Press and hold SETUP until the source key LED blinks twice, then release. 3. Press 9 7 8 . The source key LED blinks twice. 4. Press the key to which yo...
Page 12 - on this remote after entering the channel number; SPECIFICATIONS; LIMITED WARRANTY
10 PROBLEM: 5. CH+, CH-, and LAST do not work for your RCA TV. SOLUTION: • Due to RCA design from 1983 to 1987, only the original remote control will operate these functions PROBLEM: 6. Channels do not change properly when directly entering digits to change channels. SOLUTION: • If the original remo...