Niles HPS-4/HPS-6 - Manual

Niles HPS-4/HPS-6 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – TABLE OF CONTENTS; Introduction; Balancing Speaker Volume; SPECIFICATIONS; Frequency Response
Page 3 – Installation Considerations; Power Handling; Turn on the amplifier or receiver and select a source, such; “TECH TIP”; When playing the following speakers:; or 2 pairs of 8-ohm speakers; The Protection button should be:; OFF
Page 4 – Using the HPS Series with Tube-Type Amplifiers; Installation; Select a convenient mounting location.; “Tech Tip”; Figure 4; Installing the Connectors; Figure 3; Removing the Connectors
Page 5 – Figure 1; Using a
Page 6 – Figure 2; Operation; Playing One Pair of Speakers At a Time
Page 7 – Playing Two or More Speaker Pairs Simultaneously; Make sure the amplifier or receiver power is OFF and set; Type of Speaker Wire; Tools
Page 8 – Constant Protection Switch; Features and Benefits; TECH

Loading the manual

Niles Audio

Corporation

www.nilesaudio.com

12331 S.W. 130 Street

Miami, Florida 33186

Tel: (305) 238-4373

Fax: (305) 238-0185

©2004 Niles Audio Corporation. All rights reserved. Niles, the Niles logo and Blending High Fidelity and
Architecture are registered trademarks of Niles Audio Corporation. Because we strive to improve our products,
Niles reserves the right to change product specifications without notice. The technical and other information
contained herein is not intended to set forth all technical and other specifications of Niles products. Additional
information can be obtained on-line at www.nilesaudio.com or by calling Niles at 1-800-289-4434. Printed in
China 1/04 DS00358ACN

HPS-4/HPS-6

L E N D I N G

I G H

I D E L I T Y

A N D

R C H I T E C T U R E

I N S T A L L A T I O N & O P E R A T I O N G U I D E

HIGH POWER SPEAKER SELECTION SYSTEM

HPS-4/HPS-6

DS00358ACN/HPS-4/HPS-6 Printer 11/19/03 5:05 PM Page 15

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - TABLE OF CONTENTS; Introduction; Balancing Speaker Volume; SPECIFICATIONS; Frequency Response

Introduction The HPS series allows you to connect multiple pairs of speak-ers to your stereo receiver or amplifier and play any one pair,any combination of pairs, or all pairs at once. You don't haveto worry about overloading your amplifier. The HPS-4 andHPS-6 have a protection circuit that keeps yo...

Page 3 - Installation Considerations; Power Handling; Turn on the amplifier or receiver and select a source, such; “TECH TIP”; When playing the following speakers:; or 2 pairs of 8-ohm speakers; The Protection button should be:; OFF

Installation Considerations Power Handling The HPS series is designed for use with a receiver or amplifierhaving a maximum power output of 250 watts per channel at8 ohms. Damage caused by the use of a higher-power receiv-er or amplifier will void the warranty. Consult your Niles deal-er, or receiver...

Page 4 - Using the HPS Series with Tube-Type Amplifiers; Installation; Select a convenient mounting location.; “Tech Tip”; Figure 4; Installing the Connectors; Figure 3; Removing the Connectors

Using the HPS Series with Tube-Type Amplifiers Virtually all tube amplifiers must have a load connected at alltimes. If the amplifier to be connected to the HPS-4/HPS-6 is atube amplifier, be sure to always have at least one pair of speak-ers switched on at all times. An alternative is to permanentl...