Napoleon GT8N - Manuals - manualsarea.com

Page 2 - PG 2-5 INTRODUCTION; VENTING; TABLE of CONTENTS; PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE

2 W415-0619 / A /08.09.07 PG 2-5 INTRODUCTION Warranty Dimensions General Instructions General Information Care of Glass & Plated Parts 5-6 VENTING Venting Lengths Air Terminal Locations 7-9 INSTALLATION/FRAMING Wall & Ceiling Protection Using Flexible Vent Components Horizontal Air Terminal...

Page 3 - NAPOLEON® GAS FIREPLACE PRESIDENT’S LIFETIME LIMITED WARRANTY; The following materials and workmanship in your new Napoleon® gas; CONDITIONS AND LIMITATIONS

3 W415-0619 / A / 08.09.07 ALL SPECIFICATIONS AND DESIGNS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE DUE TO ON-GOING PRODUCT IMPROVEMENTS. NAPOLEON® IS A REGISTERED TRADEMARK OF WOLF STEEL LTD. PATENTS U.S. 5.303.693.801 - CAN. 2.073.411, 2.082.915. © WOLF STEEL LTD. NAPOLEON® products are manufactu...

Page 4 - FIGURE 1; GENERAL INSTRUCTIONS

4 W415-0619 / A /08.09.07 16 3 / 4 Minimum clearance to combustible construction from fi replace and vent surfaces: Fireplace framing: - 6” to top - 0” to stand-offs (rear and sides) Vent pipe: - 1” Recessed depth: - 7” FIGURE 1 THIS GAS FIREPLACE SHOULD BE INSTALLED AND SERVICED BY A QUALIFIED INST...

Page 5 - CARE OF GLASS, AND PLATED PARTS; VENTING LENGTHS; FIGURE 2a; FIGURE 2c

5 W415-0619 / A / 08.09.07 WARNING DO NOT SUBSTITUTE MATERIALS. USE CARE WHEN HANDLING GLASS COMPONENTS DO NOT STIKE, OR SLAM SHUT. DO NOT OPERATE WITH BROKEN GLASS. The glass is 3/16” ceramic glass available from your Napoleon® / Wolf Steel Ltd. dealer. Clean the glass after the fi rst 10 hours of ...

Page 6 - FIGURE 3

6 W415-0619 / A /08.09.07 N B B G A F C H H L K J M FIGURE 3

Page 7 - INSTALLATION / FRAMING; WALL AND CEILING PROTECTION; USING FLEXIBLE VENT COMPONENTS; FIGURE 4

7 W415-0619 / A / 08.09.07 INSTALLATION / FRAMING WALL AND CEILING PROTECTION This application occurs when venting through an exterior wall. Having determined the air terminal location, cut and frame a hole in an exterior wall with a minimum square opening of 8” W x 8” H. IMPORTANT: For optimum perf...

Page 8 - FIREPLACE VENT CONNECTION; FIGURE 7; GAS INSTALLATION; FIGURE 9; FRAMING

8 W415-0619 / A /08.09.07 The has been designed to be installed mid-way up an outside wall. When installing this unit close to the fi nished fl oor, the unit must be raised a minimum of 2” (unobstructed) to allow for full rotation of the control door. It is not necessary to install a hearth extensio...

Page 9 - ELECTRICAL CONNECTION; HARD WIRING CONNECTION

9 W415-0619 / A / 08.09.07 MAINTAIN THESE MINIMUM CLEARANCES TO COMBUSTIBLES: Fireplace framing - 6” to top - 0” to stand-offs (rear and sides) Fireplace fi nishing - 0” FIGURE 14 Do NOT use the fi replace if any part has been under water. Call a quali fi ed service technician IMMEDIATELY to have th...

Page 10 - FINISHING; GLASS REMOVAL; LIGHT INSTALLATION

10 W415-0619 / A /08.09.07 FRAME INSTALLATION 1. Align the two holes in the upper portion of the hinge on the control door assembly to those in the bottom trim bracket and secure using two of the screws supplied. (FIGURE 17) 2. Rest the top lip of the Torch TM frame on the top trim bracket, and the ...

Page 11 - OPERATING INSTRUCTIONS

11 W415-0619 / A / 08.09.07 A. This fi replace is equipped with an ignition device which automatically lights the burner. Do not try to light by hand. B. Before operating, smell all around the fi replace area for gas and next to the fl oor because some gas is heavier than air and will settle on the ...

Page 12 - ADJUSTMENTS; GAS PRESSURE ADJUSTMENT; MAINTENANCE

12 W415-0619 / A /08.09.07 Closing the air shutter will cause a more yellow fl ame, but can lead to carboning. Opening the air shutter will cause a more blue fl ame, but can cause fl ame lifting from the burner ports. The fl ame may not appear yellow immediately; allow 15 to 30 minutes for the fi na...

Page 13 - REPLACEMENTS; REPLACEMENT PARTS; FLEXIBLE VENT KITS

13 W415-0619 / A / 08.09.07 # PART NO. DESCRIPTION 1 W225-0216 DOOR FRAME 2* W562-0008 DOOR GASKET 3* W010-1736 DOOR LATCH ASSEMBLY 4 W010-1743 GLASS C / W GASKET 5* W300-0088 GLASS6 W100-0104 BURNER 7 W357-0006 IGNITOR8 W190-0026 CONTROL, MODULE 9* W750-0183 WIRE HARNESS 10* W750-0184 IGNITION CABL...

Page 14 - TROUBLE SHOOTING GUIDE; SYMPTOM

14 W415-0619 / A /08.09.07 TROUBLE SHOOTING GUIDE BEFORE ATTEMPTING TO TROUBLESHOOT , PURGE YOUR UNIT AND INITIALLY LIGHT THE IGNITOR AND THE MAIN BURNER WITH THE GLASS DOOR OPEN . SYMPTOM PROBLEM TEST SOLUTION Electrode sparks, burner ignites, electrode contiunes to spark for complete 7 seconds, bu...

Page 15 - Fireplace Service History; This fireplace must be serviced annually depending on usage

15 W415-0619 / A / 08.09.07 Fireplace Service History This fireplace must be serviced annually depending on usage DA TE DEALER NAME SER VICE TECHNICIAN NAME SER VICE PERFORMANCE SPECIAL CONCERNS

Page 16 - NOTES