Milan Technology E-FL-HB-0400 - Manuals

Milan Technology E-FL-HB-0400 – Manual in PDF format online.

Manuals:

Manual Milan Technology E-FL-HB-0400

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8

Summary

Page 2 - TECHNICAL SPECIFICATIONS; Operating Temperature:

E-FL-HB-0x00 IN THE NETWORK Install one E-FL-HB-0x00hub and use fiber cable toset up a workgroup byconnecting the hub toterminal devices. Install an optional backboneuplink adaptor at the back ofthe hub and use 10BASE-2,10BASE-5, or fiber cable toconnect the workgroup to anetwork backbone. Cascade t...

Page 3 - CABLE SPECIFICATIONS; 0BASE-2 Cable Specifications; AUI CABLE AND CONNECTOR SPECIFICATIONS; AUI CONNECTOR CHARACTERISTICS:; 0BASE-FL Cable Specifications

E-FL-HB-0x00 in Half-Duplex Network The 5-4-3 Rule applies separately to each collision domain. NOTE: Acollision domain is any Carrier Sense Multiple Access with Collision Detection(CSMA/CD) network in which a collision will occur if two attached stationstransmit at the same time. A segment is the c...

Page 4 - INSTALLATION; Optionally Install Backbone Uplink Adapter; CAUTION: Do NOT force connection. Failure to observe this caution; YES; Check fiber cables for proper connection.

INSTALLATION Optionally Install Backbone Uplink Adapter WARNING: Remove AC line cord from power source before installingbackbone uplink adaptor in E-FL-HB-0x00. Failure to observe this warningcould result in personal injury or death. CAUTION: Wear a grounding device and observe electrostatic dischar...

Milan Technology Manuals