Miele KM 326G - Manuals - manualsarea.com

Page 2 - Warning; english

1 * Do not store or use gasoline or other flammable vapors and liquidsin the vicinity of this or any otherappliance. * What to do if you smell gas – Do not try to light any appliance.– Do not touch any electrical switch. – Do not use any phone in your building. – Immediately call your gas supplier u...

Page 4 - Warning and safety instructions; Save the instructions.; Marking

2 3 Warning and safety instructions 1. Read all the instructions before using your hob unit. 2. Use the unit only for its intended purpose. 3. Do not use the unit unless all parts are properly in place according to the installation and operating instructions. 4. Before servicing, disconnect the powe...

Page 6 - Outer ring; Important notes for the user; Advice; Before starting check

4 5 Gas burners If a burner blows out, the electronic ignition automatically sparks all burners to relight the flame. The flame is lit by means of an electrical ignition device. When the burner control is pressed and turned, a high voltage flows into the electrode by the burner. Sparks are created. ...

Page 8 - How to use gas burners

6 7 Pans and pots The heat from the burner is transferred via the pan base. If the base is thick, the heat will take longer to reach the contents, but the base will have a more uniform temperature. Thin and light pans will cause food to burn more easily. To use the gas as efficiently as possible, it...

Page 10 - Cleaning and maintenance

8 9 Disposal of packaging andappliance The packaging of the appliance is recyclable. It is made up of: – cardboard – polyethylene film (PE) – CFC-free polystyrene (PS rigid foam) Please dispose of these materials in a responsible way in accordance with the regulations of your local authority. Your l...

Page 12 - Electrical circuit diagram; Troubleshooting

10 11 Electrical circuit diagram 5-point gas re-ignitor120 Vac/60 Hz/3 VA spark/sense re-ignition earth N A SW1SW2SW3SW4SW5 S1 S2 S3S4 S5 120V/60HZ main connecting board L N TWO ZONE WOK BURNER 12-leds com S1 LED com S1 LED 9-leds com S1 LED 9-leds 9-leds com S1 LED com S1 LED 9-leds FRONT RIGHT BAC...

Page 16 - Building-in dimensions

14 15 There may be a wall at the rear and a wall or tall units at one side. On the other side, however, no unit or divider may stand higher than the hob. Building-in dimensions Prepare a cut-out in the worktop according to the dimensions given in the diagram above. 35 7/16 " (900 mm) 20 3/16 ...

Page 18 - Clearance above and around the appliance; not allowed

16 17 Building-in 1. Make the cut-out in the work surface. Ensure that there is sufficient space allowed at the sides and at the rear. 2. Attach the sealing strip to the underside of the hob and the aeration profile. 3.* Connect the pressure regulator supplied at the angle-joint, ensuring that they ...

Page 20 - Safety Instructions; Parts; WARNING

Safety Instructions Warning This conversion kit must be installed by a qualified service agency. This conversion kit is for use with Miele gas hob KM 326G only. Conversion kit type number AH 102 C4U These conversion instructions are to be used together with the operating and installation instruction...

Page 22 - Conversion instructions

Remove the three screws securing the dual ring wok burner. Remove the wok burner base plate. Lift the ceramic tray from the hob. Note Each regulator shaft is equipped with a black ring. This ring may cling to the rubber seal in the ceramic tray. Check and remove the rings from the rubber seals. For ...

Page 24 - gaspipe

23 22 1. First loosen the 8 mm ring securing the gas feed pipe. Disconnect the gas pipe. The actual injector is a thin metal cap mounted between the two brass fittings attached to the left of the wok burner body. Inner ring injector 2. Two 12 mm wrenches are needed to separate the fittings. Use one ...