Makita LS1016 - Manuals

[3] DISASSEMBLY/ASSEMBLY[3]-1. Blade case, Motor section (cont.) DISASSEMBLING Fig. 10 Correct Wrong Fig. 11 Fig. 12 Sleeve 6 2. Holding Blade case by hand, lift up it slowly until notch A aligns with Stopper pin. And then, push Knob 20. 1. Remove M5x18 Hex socket head bolt and Sleeve 6. Then pull K...

[4] ADJUSTMENT[4]-5. Laser (for LS1016L only) 1) Remove M10x20 Hex flange head bolt, Outer flange, Inner flange and Blade. Then separate Safety cover section from Blade case complete. (Fig. 78) 2) Remove Protector. (Fig. 79)3) Place Flat washer 16 on Spindle (Fig. 80) and fasten 1R315 and Flat washe...

P 26/ 37 R epair [4] ADJUSTMENT[4]-5. Laser (for LS1016L only: Cont.) Note: 1) In the process 10) and 11), backlash of M4x6 Hex socket set screw A or B may be happened. Therefore, turn each M4x6 Hex socket set screw clockwise carefully to prevent backlash. 2) Be sure to distinguish the role of M4x6 ...

C ircuit diagram Field (viewed from Armature gear side) Circuitplate Laser circuit Trans-former Laser switchunit Power supply circuit Laser section exclusively for LS1016L Motor housing Blade case Handle cover and Handle section COM NC Main switch Color index of lead wires' sheath 220-240V area wher...

Wiring around Case of LS1016L Case Case Connector for connecting to that of Laser switch unit Inside of Case Outside of Case Controllerside Fix Lead wires (blue) with Lead wire holder. Pay attention not to pinch Lead wiresbetween Handle and Case. Assemble Power supplycircuit (Transformer and Circuit...

Do not route Field lead wires (white and purple) between Armature and Baffle plate. case of Powersupply circuit Pass the Lead wires from Motorhousing through this notch of Handle. Wiring in Motor Housing and Handle for Argentina and 220 - 240V area where Radio interference suppression is required. P...

Case of Powersupply circuit Pass Lead wires from Motor housing through the notch of Handle. Wiring in Motor Housing and Handle for 220 - 240V area where Radio Interference suppression is not required. Switch for protectionof brake coil Controller Insulated terminal Field Lead wires * (orange) * (bla...

case of Powersupply circuit Pass Lead wires from Motor housingthrough the notch of Handle. Wiring in Motor housing and Handle for UK 110V Pass the Lead wires through the Rib for Laser switch unit. Do not putthe Lead wires on the Ribs. Controller Terminalblock Field lead wires * (orange) * (black) * ...

Wiring of Laser circuit complete of LS1016L for all countries [Blade case after removal of Lead cover] [Laser circuit section viewed from front side] rib A rib B Boss Pay attention not to pinchLead wires between ribs ofBlade case designated in gray color and Lead cover. rib C Route Lead wires ofLase...