Makita C - Manuals - manualsarea.com

Page 2 - Page; TABLE OF CONTENTS; GENERAL INFORMATION

Page 2 TABLE OF CONTENTS SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 GLOSSARY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 3 - IMPORTANT SAFETY INSTRUCTIONS; WARNING; HAZARD

Page 3 IMPORTANT SAFETY INSTRUCTIONS *SAVE THESE INSTRUCTIONS* WARNING IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAMAGE. READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. HAZARD Risk ofUnsafeOperation WHAT CAN...

Page 7 - GLOSSARY; This air compressor; INSPECTION

Page 7 GLOSSARY CFM: Cubic feet per minute. SCFM: Standard cubic feet perminute; a unit of measure of airdelivery. PSIG: Pounds per square inchgauge; a unit of measure ofpressure. CUT-IN PRESSURE: While themotor is off, air tank pressuredrops as you continue to useyour accessory or air tool. Whenthe...

Page 8 - STORAGE; Protect the electrical cord and; DESCRIPTION OF; an automatic

Page 8 product was shipped directly toyou, report any damages to thecarrier and arrange for inspectionof goods immediately. STORAGE Before you store the aircompressor, make sure you dothe following: 1. Review the “Maintenance” and “Operating Procedures”sections and performmaintenance as necessary. B...

Page 9 - INSTALLATION AND; intake

Page 9 reaches “cut-out” pressure.PRESSURE SWITCH: Thepressure switch automaticallystarts the motor when the airtank pressure drops to thefactory set “cut-in” pressure. Itstops the motor when the airtank pressure reaches thefactory set “cut-out” pressure. SAFETY VALVE: If the pressureswitch does not...

Page 11 - OPERATING; Daily Star t-up Checklist

Page 11 grounding plug. The plug mustbe used with an outlet that hasbeen installed and grounded inaccordance with all local codesand ordinances. The outlet musthave the same configuration asthe plug. DO NOT USE ANADAPTER. Inspect the plug and cord beforeeach use. Do not use if there aresigns of dama...

Page 12 - MAINTENANCE; Check for any unusual noise

Page 12 MAINTENANCE WARNING: UNIT CYCLESAUTOMATICALLY WHENPOWER IS ON. WHENDOING MAINTENANCE, YOU MAY BE EXPOSED TO VOLTAGE SOURCES,COMPRESSED AIR ORMOVING PARTS. PERSONALINJURIES CAN OCCUR.BEFORE PERFORMING ANY MAINTENANCE ORREPAIR, UNPLUG THECOMPRESSOR AND BLEEDOFF ALL AIR PRESSURE. To ensure effi...

Page 13 - SERVICE; Motor

Page 13 SERVICE INSTRUCTIONS WARNING: SAFETYVALVE – INSPECTIONIF THE SAFETY VALVE DOES NOT WORK PROPERLY, OVER-PRESSURIZATION MAYOCCUR, CAUSING AIR TANK RUPTURE OR AN EXPLOSION.OCCASIONALLY PULLTHE RING ON THE SAFETY VALVE TO MAKESURE THAT THE SAFETYVALVE OPERATES FREELY.IF THE VALVE IS STUCK OR DOE...

Page 14 - TROUBLESHOOTING GUIDE; • Move the pressure switch lever to the

Page 14 TROUBLESHOOTING GUIDE PERFORMING REPAIRS MAY EXPOSE VOLTAGE SOURCES, MOVING PARTS OR COMPRESSED AIR SOURCES. PERSONAL INJURY MAY OCCUR. PRIOR TO ATTEMPTING ANY REPAIRS, UNPLUG THE COMPRESSOR AND BLEED OFF TANK AIR PRESSURE. CAUSE Defectivepressureswitch. Improperwiring. Fittings arenot tight...

Page 17 - COMPRESSOR MAIntEnAnCE LOG; DAtE

COMPRESSOR MAIntEnAnCE LOG DAtE tyPE Of MAIntEnAnCE OR REPAIRS Page 1

Page 19 - MAkItA wARRAnty; Servicio y Garantía / Registro de Producto; MAKITA LIMITED ONE YEAR WARRANTY

MAkItA wARRAnty Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 japan Page Servicio y Garantía / Registro de Producto MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be free of defects...

Makita C - Manuals

Manuals:

Manual Makita C

Summary

Makita Manuals