Makita 4340T - Manuals

7 Keeping that situation, insert the saw blade into the blade clamp as far as thetwo protrusions of the blade can not be seen. Return the tool opener to its original position. After installing, always make sure that the blade is securely held in place bytrying to pull it out. CAUTION: • Do not open ...

9 Cutouts Cutouts can be made with either of two methods A or B. A) Boring a starting hole For internal cutouts without a lead-in cut from an edge, pre-drill a startinghole 12 mm or more in diameter. Insert the blade into this hole to startyour cut. B) Plunge cutting You need not bore a starting hol...

10 Dust extraction The dust nozzle (accessory) is recommended to perform clean cutting opera-tions. To attach the dust nozzle on the tool, insert the hook of dust nozzle into thehole in the base. The dust nozzle can be installed on either left or right side of the base. Then connect a Makita vacuum ...

12 Guide rail adapter set (accessory) When cutting parallel and uniform width or cutting straight, the use of the guiderail and the guide rail adapter will assure the production of fast and clean cuts. To install the guide rail adapter, insert the rule bar into the square hole of thebase as far as i...

13 Anti-splintering device For splinter-free cuts, the anti-splintering device can be used. To install theanti-splintering device, move the tool base all the way forward and fit it from theback of tool base. When you use the cover plate, install the anti-splinteringdevice onto the cover plate. CAUTI...