Makita 4340T - Manual - manualsarea.com

Page 2 - SPECIFICATIONS

2 SPECIFICATIONS • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. SYMBOLS END201-2 The following show the symbols used for the equipment.Be sure that you understan...

Page 3 - GENERAL SAFETY RULES; Read all instructions.; Failure to follow all instructions listed below may result in; SAVE THESE INSTRUCTIONS

3 GENERAL SAFETY RULES GEA001-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of thewarnings listed below refers to your mains-operated (corded) power tool or battery-operated (co...

Page 6 - Lighting up the lamps; ASSEMBLY; Installing or removing saw blade

6 CAUTION: • The speed adjusting dial can be turned only as far as 5 and back to 1. Donot force it past 5 or 1, or the speed adjusting function may no longerwork. The tools equipped with electronic function are easy to operate because of thefollowing features. Constant speed control Electronic speed...

Page 7 - Hex wrench storage; OPERATION

7 Keeping that situation, insert the saw blade into the blade clamp as far as thetwo protrusions of the blade can not be seen. Return the tool opener to its original position. After installing, always make sure that the blade is securely held in place bytrying to pull it out. CAUTION: • Do not open ...

Page 9 - Cutouts; Finishing edges

9 Cutouts Cutouts can be made with either of two methods A or B. A) Boring a starting hole For internal cutouts without a lead-in cut from an edge, pre-drill a startinghole 12 mm or more in diameter. Insert the blade into this hole to startyour cut. B) Plunge cutting You need not bore a starting hol...

Page 10 - Dust extraction

10 Dust extraction The dust nozzle (accessory) is recommended to perform clean cutting opera-tions. To attach the dust nozzle on the tool, insert the hook of dust nozzle into thehole in the base. The dust nozzle can be installed on either left or right side of the base. Then connect a Makita vacuum ...

Page 12 - Cover plate

12 Guide rail adapter set (accessory) When cutting parallel and uniform width or cutting straight, the use of the guiderail and the guide rail adapter will assure the production of fast and clean cuts. To install the guide rail adapter, insert the rule bar into the square hole of thebase as far as i...

Page 13 - Anti-splintering device; MAINTENANCE

13 Anti-splintering device For splinter-free cuts, the anti-splintering device can be used. To install theanti-splintering device, move the tool base all the way forward and fit it from theback of tool base. When you use the cover plate, install the anti-splinteringdevice onto the cover plate. CAUTI...

Page 14 - Memo

Makita 4340T - Manual

Table of Contents:

Summary

Other Makita Models