Page 2 - SPECIFICATIONS; Symbols
2 ENGLISH SPECIFICATIONS Model 3709 Collet chuck capacity 6 mm or 1/4" No load speed (min -1 ) 30,000 Overall length 199 mm Net weight 1.5 kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specific...
Page 3 - TRIMMER SAFETY WARNINGS
3 9. If operating a power tool in a damp location is unavoidable, use a ground fault circuit interrupter (GFCI) protected supply. Use of an GFCI reduces the risk of electric shock. Personal safety 10. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a...
Page 4 - Adjusting bit protrusion; ASSEMBLY
4 10. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit. 11. Be careful of the bit rotating direction and the feed direction. 12. Do not leave the tool running. Operate the tool only when hand-held. 13. ...
Page 5 - Installing or removing trimmer bit; OPERATION; Templet guide
5 Installing or removing trimmer bit 1 2 3 006615 CAUTION: • Use only the wrenches provided with the tool. Insert the bit all the way into the collet cone and tighten the collet nut securely with the two wrenches. To remove the bit, follow the installation procedure in reverse. OPERATION Set the too...
Page 6 - Circular work
6 the templet and move the tool with the templet guide sliding along the side of the templet. 12 34 5 005435 NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the router bit and the outside of the templet guide. The distance (X) can be c...
Page 7 - MAINTENANCE; Replacing carbon brushes
7 For cutting circles between 121 mm and 221 mm in radius. 1 23 4 5 006620 NOTE: • Circles between 172 mm and 186 mm in radius cannot be cut using this guide. Align the center hole in the straight guide with the center of the circle to be cut. Drive a nail less than 6 mm in diameter into the center ...
Page 8 - ACCESSORIES; Router bits; Straight bit; Drill point flush trimming bit
8 1 2 006622 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool...
Page 10 - Ball bearing chamfering bit; Ball bearing beading bit; Ball bearing cove beading bit; Ball bearing roman ogee bit
10 Ball bearing chamfering bit 005132 mm D A 1 L 1 26 42 6 1/4" 45 60 6 20 A 2 8 8 41 L 2 12 11 006467 Ball bearing beading bit 005133 mm D A 1 A 2 A 3 L 1 L 2 L 3 R 6 6 5.5 4 4.5 10 12 7 26 12 8 42 20 12 8 40 006468 Ball bearing cove beading bit 005134 mm D A 1 A 2 A 4 L 1 L 2 L 3 R 6 6 5.5 3 5...
Page 12 - Makita Corporation
