La Crosse Technology WS-9057U - Manuals

Page 2 - SETUP; WHEN ONE TRANSMITTER IS USED

5 SETUP WHEN ONE TRANSMITTER IS USED 1. First, insert the batteries in the transmitter (see “ How to install and replace batteries in the Thermo-hygro outdoor transmitter ” on page 11). 2. Within 2 minutes of powering up the transmitter, insert the batteries in the Weather Station (see “ How to inst...

Page 3 - “Setting Up”; ABOUT WWVB RADIO CONTROLLED TIME

9  When the weather station is receiving the WWVB time signal, the outdoor transmitter data signal will temporarily not be received by the weather station. During this short period of time, the outdoor readings shown on the weather station will not be renewed until the WWVB time signal is successfu...

Page 4 - LCD SCREEN

13 will sound for every second. It is possible that your wireless weather station may not be exactly on the second due to the variance in the quartz. However, the clock will adjust the quartz timing over the course of several days to be very accurate; under 0.10 seconds per day. FUNCTION KEYS: The W...

Page 5 - LCD CONTRAST SETTING:; Time Zone setting; Daylight saving time; setting

17 * When the signal is successfully received by the Weather Station, the outdoor transmission icon will be switched on. If not successful, the icon will not be shown on LCD. The user can then easily see whether the last reception was successful (icon on) or not (icon off). A short blinking of the i...

Page 6 - Manual time setting; MANUAL TIME SETTING:; Calendar setting

21 12/24-HOUR FORMAT SETTING: The hour display can be selected to show hours in 12-hour or 24-hour settings. (Default 12-Hour) 1. Use the OUT/+ key to toggle between “12H” or “24H”. 2. Confirm with the SET key and enter the Manual time setting . MANUAL TIME SETTING: If Weather Station cannot detect ...

Page 7 - RELATIVE AIR PRESSURE VALUE SETTING; WEATHER FORECASTING ICON SENSITIVITY SETTING:; Manual settings; TO EXIT THE MANUAL SETTING MODE; Alarm setting; SNOOZE SETTING AND STOPPING THE ALARM:

25 2. Confirm with the SET key and enter the Relative air pressure value setting . Note: Units of weather icon sensitivity and air pressure history are not affected. They are always expressed in hPa. RELATIVE AIR PRESSURE VALUE SETTING The default relative pressure value is 29.92 inHg (1013 hPa). Th...

Page 8 - INDOOR RELATIVE HUMIDITY AND INDOOR TEMPERATURE:; THE COMFORT LEVEL INDICATOR:; Comfortable; TOGGLING AND RESETTING THE INDOOR READINGS:; Sunny Cloudy with sunny intervals Rainy

29 INDOOR RELATIVE HUMIDITY AND INDOOR TEMPERATURE: The indoor temperature and humidity data and the indoor comfort indicator are automatically updated and displayed on the second section of the LCD. Indoor relative humidity in RH% Indoor temperature in °C or ºF MAX icon New Moon Small Waxing Cresce...

Page 9 - WEATHER TENDENCY INDICATOR; pressure, it will remain permanently displayed on the LCD.; OUTDOOR TEMPERATURE AND HUMIDITY DATA; The MIN or MAX data needs to be reset individually.; When more than 1 transmitter used:

33 If the Weather station is moved to another location significantly higher or lower than its initial standing point (for example from the ground floor to the upper floors of a house), discard the weather forecast for the next 48-60 hours. By doing this, the Weather Station will not mistake the new ...

Page 10 - “Setting up”; POSITIONING THE WEATHER STATION; FOLDOUT TABLE STANDS:; POSITIONING THE THERMO/HYGRO TRANSMITTER:

37 2. Use OUT/+ key to view the MIN/MAX temperature and humidity data for the selected transmitter. 3. To reset the minimum and maximum temperature and humidity data, and the times at which they were recorded, press the SET key continuously for about 3 seconds. This will reset the MIN/MAX data recor...