La Crosse Technology WS-811561 - Manuals

Page 3 - Initial Set Up and Wireless Synchronization; Initialize the Sensor; Sensor battery voltage must be higher than

Page 3 of 12 TX61U-IT Wireless Solar-Powered Outdoor Sensor: • The TX61U-IT sensor sends the collected outdoor temperature to your existing wireless display by way of a 200 Ft wireless signal. • High-efficiency modern solar panel maintains full charge with minimal light • Stores solar power for cont...

Page 4 - Set the Time and Date

Page 4 of 12 automatically. When the battery voltage charges to 2.5V, the LCD will turn on and the transmission of signal will start again. 2. Install Batteries into Wireless Display Insert 2 new "AA", 1.5 volt ALKALINE batteries into the wireless display according to the polarity marked on ...

Page 5 - : North American time zones are negative; US

Page 5 of 12 attempted at the full hour between 12:00 am to 6:00 am. For best reception, place the display with the front or back facing Colorado. After a successful reception, no more reception attempt would be made until the following day. If the display is in an area of your home where the WWVB s...

Page 6 - Setting the Time Alarm; alarm icon; ALARM; seconds until the hours digits flash. Use the “; PLUS; confirm your setting and move to setting the minutes.

Page 6 of 12 4. Set Time - Hour: Press the “SET” button a fourth time and the Hours digits will flash. Use the “PLUS“ button to select the correct hour. 5. Set Time - Minute : Press the “SET” button a fifth time and the Minutes digits will flash. Use the “PLUS“ button to select the correct minute. 6...

Page 7 - Battery Replacement Information

Page 7 of 12 The Minutes digits of the Alarm Time will flash. Use the “ PLUS ” button to set the minutes. You can hold the " PLUS " button in to speed up the setting of minutes by using five minute increments. Press the " ALARM " button to confirm your minutes setting and to end the ...

Page 8 - Installation Notes; Do

Page 8 of 12 Installation Notes Point the TX61U-IT solar panel toward the best available light source to recharge the batteries, but avoid a location in direct sun as it will cause incorrect temperature readings. We recommend facing the solar panel East to catch the early morning sun, and placing un...

Page 9 - Mounting the Units; The TX61U-IT Sensor; Insert the TX61U-IT sensor into the bracket.; Table Standing and Other Mounting Options; Before permanently; The Wireless Display; fold out legs

Page 9 of 12 the outdoor temp, this means that the sensor is either located too close or too far from the wireless display. Please adjust the location of the TX61U-IT sensor and try again. If it fails again, please restart the set up procedure (see below). Mounting the Units The TX61U-IT Sensor The ...

Page 10 - Online Resources; Care and Maintenance; Troubleshooting; For more product information, visit; Batteries; Please use plain; Alkaline; batteries in the wireless

Page 10 of 12 Online Resources Visit the WS-811561 page online at:

Page 11 - La Crosse T; echnology, Ltd provides a 1-year limited

Page 11 of 12 • Ensure correct polarity Ensure that the wireless display has fresh batteries and are installed using correct polarity as shown inside the battery compartment (+). Sensor Location : Before permanently fixing the TX61U-IT sensor wall bracket, temporarily place both the sensor and the w...

Page 12 - For warranty work, technical support, or; La Crosse Technology, Ltd; For information on other products visit

Page 12 of 12 surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than...