La Crosse Technology WS-7032U - Manuals

Page 2 - Battery installation

2 TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 3 Quick set-up guide 4-5 Battery installation 6-7 Features: Indoor temperature 8 Weather Forecast icons & tendency arrows 8-10 Outdoor temperature 10 Mounting 11-13 Troubleshooting 14 Maintenance and Care instructions 15 S...

Page 3 - INVENTORY OF CONTENTS; Temperature; ADDITIONAL EQUIPMENT; One Philips screwdriver.

3 INVENTORY OF CONTENTS 1. WS-7032U—Weather Station. 2. TX6U—Remote Temperature Sensor. 3. Three each, ½” Philips screws. 4. One strip double-sided adhesive tape. 5. Instruction manual & Warranty card. ADDITIONAL EQUIPMENT 1. Two fresh AAA 1.5V batteries (for weather station). 2. Two fresh AA 1....

Page 4 - Place the batteries into the; outdoor; first then into the indoor station.

4 QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor station and outdoor remote 3 to 5 apart. 2. Batteries should be out of both units for 10 minutes. 3. Place the batteries into the outdoor remote first then into the indoor station. (Al...

Page 9 - Sunny—

9 an accurate forecast—causing a necessity to disregard all weather forecasting for 12-24 hours after the unit has been set-up, reset, or moved from one altitude to another (i.e. from one floor of a building to another). In areas where the weather is not affected by the change of air pressure, this ...

Page 10 - F or; MOUNTING

10 with rain,” or the reverse. It will not change from “sunny” directly to “rainy,” although it is possible for the change to occur quickly. If the symbols do not change then the weather has not changed, or the change has been too slow and gradual to register. B. WEATHER TENDENCY ARROWS Other possib...

Page 11 - THE REMOTE TEMPERATURE SENSOR; with the use of screws, or; MOUNTING WITH SCREWS; Place the mounting bracket over the desired

11 Note: Extreme and sudden changes in temperature will decrease the accuracy of the Weather Temperature Station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To a...

Page 12 - MOUNTING WITH ADHESIVE TAPE; should be smooth; WEATHER; The Weather Station

12 location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. 3. Where marked, start the screw holes into the mounting surface. 4. Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. 5. Snap the Remote Temperature...

Page 13 - No outdoor

13 with the use of a wall hanging screw (not included). A. WALL MOUNTING 1. Place a screw (not included) into an appropriate wall, leaving approximately 3/16 of an inch (5mm) extended from the wall. 2. Place the Weather Station onto the screw using the hanging hole on the backside. Gently pull the S...

Page 14 - Note: For problems not solved, please contact La Crosse; MAINTENANCE AND CARE INSTRUCTIONS

14 Solution: 1) Remove all batteries—wait 30 seconds—then reinsert into sensor first, then into the station. 2) Place sensor closer to station. 3) Be sure there are no obstructing objects. 4) Be sure all batteries are fresh. Problem: The LCD screens are faint/dim. Solution: Replace batteries. Proble...

Page 15 - Do not submerge in water.

15 temperature changes, vibration, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. • Do not submerge in water. • Immediately remove all low powered batterie...

Page 16 - displayed if outside this range.; Temperature checking intervals; times every 10 minutes.; Power Source

16 SPECIFICATIONS Temperature measuring range Indoor: 32 ° F to 104 ° F with 0.2 ° F resolution: (0 ° C to 40 ° C with 0.1 ° C resolution). “OFL” displayed if outside this range. Outdoor: -21.9 ° F to 157.9 ° F with 0.2 ° F resolution: (-29.9 ° C to 69.9 ° C with 0.1 ° C resolution). “OFL” displayed...

Page 17 - WARRANTY INFORMATION

17 WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to th...

Page 18 - MALFUNCTION OF THIS

18 The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. La Crosse Technology, Ltd will pay ground return shipping charges to the owner of the product to a USA address only. Your La Crosse Technolo...

Page 19 - La Crosse Technology

19 PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDREN’S REACH. This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequen...