La Crosse Technology WS-7014U-IT - Manuals

Page 2 - Detailed Set-Up Guide; Program Mode; Features

2 TABLE OF CONTENTS Topic Page Inventory of Contents/Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery installation 5 Program Mode Program Sequence and Default Settings 6 Function Keys 6 Setting the LCD Contrast 7 Setting the Time Zone 7-8 Daylight Saving Time Se...

Page 3 - Figure 1; Time LCD; Figure 2; INSTANT

3 INVENTORY OF CONTENTS 1. The Wireless Weather Station/ (Figure 1). 2. One remote temperature sensor with mounting bracket (Figure 2). 3. Three each, ½” Philips screws. 4. One strip double-sided adhesive tape. 5. Instruction manual and warranty card. ADDITIONAL EQUIPMENT (not included) 1. Two fresh...

Page 4 - remote temperature sensor; first then into the indoor; Example

4 signal continuously throughout the United States at 60 kHz. The signal can be received up to 2,000 miles away through the internal antenna in the Weather Station. However, due to the nature of the Earth’s Ionosphere, reception is very limited during daylight hours. The Weather Station will search ...

Page 6 - SET

6 • If the signal reception is not successful on the first frequency (915MHz) for 45 seconds, the frequency is changed to 920MHz and the learning is tried another 45 seconds. If still not successful the reception is tried for 45 seconds on 910MHz. This will also be done for re-synchronization. PROGR...

Page 7 - TIME ZONE SETTING

7 Note: There are 8 LCD contrast levels to choose from—“Lcd 0” is the lightest, and “Lcd 7” is the darkest. 3. Press and release the IN button to select the level you desire. 4. Press and release the SET button to confirm and advance to the Time Zone setting. IV. TIME ZONE SETTING 1. Press and hold ...

Page 8 - SETTING

8 “DST 0” indicates that the feature is off and the WWVB will not change times automatically. “DST 1” indicates that the feature is on and the WWVB will change times automatically. Note: Some locations (Arizona and parts of Indiana) do not follow Daylight Saving Time, and should select “DST 0.” 6. P...

Page 11 - Sunny

11 FEATURES OF THE WS-7014U-IT I. WEATHER FORECAST The weather forecasting feature is estimated to be 75% accurate and is for the next 12 to 24 hours. The weather forecast is based solely upon the change of air pressure over time. The WS-7014U-IT averages past air-pressure readings to provide an acc...

Page 12 - Adding; IV. MINIMUM AND MAXIMUM TEMPERATURE RECORDS; the

12 should be viewed as a generalization of the expected weather change (for example a “sunny” icon indicates the weather is expected to improve). The weather icons change when the unit detects a change in air pressure. The icons change in order, from “sunny” to “partly sunny” to “cloudy” or the reve...

Page 14 - CH; MOUNTING

14 LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. 4. The outdoor temperature from the first sensor (channel 1) should then be displayed on the Weather station. If this does not happen and the signal reception icon is not shown, after 2 minutes, t...

Page 18 - La Crosse Technology

18 determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service...