La Crosse Technology WS-2510 - Manuals

9 2.3.8 Information on the storage of solar cell powered outdoor sensors These sensors receive their operating voltage from a solar cell that charges an internal battery to provide power for periods of darkness and bad weather. If one of these sensors is out of action for some time and does not rece...

11 Illumination time for AC adaptor operation The illumination time for AC adaptor operation (“line”) is displayed in the “LIGHT” field (touch screen field 1). A setting here is only meaningful when the weather station is powered by means of the AC adaptor power supply. The time displayed shows in h...

12 Calibration of the rainfall reading indicator The rainfall measuring system is delivered with a very high accuracy, so that normally no calibration is required. A calibration only becomes necessary when very high accuracy is required for professional use or for special purposes. Before starting t...

13 Setting the air pressure display units The display units for air pressure are shown in touch screen field 11 on the right hand side next to the air pressure value. The factory setting is hPa. - By touching field 11 the display units can be switched between hPa, mmHg or inHg. Keypad beep on/off - ...

14 4 1 3 2 The seconds are automatically set to zero. - The WWVB reception can also be switched on or off by means of the “WWVB” touch screen field as long as the time is flashing (radio mast symbol on or off respectively). - In addition, it now possible to select the display format for the time, da...

17 4. Here, the “Graph” symbol shows that the trend display for the wind direction has been selected in the history field. It only appears if it has previously been selected (see 3.2.6.:“History”). The trend can be displayed in km/h, m/s, mph or knots. However, if Beaufort or degrees have been chose...

18 The maximum values the last 8 days are displayed. 3. Here, the “Graph” symbol shows that the trend display for the air pressure has been selected in the history field. It only appears if it has previously been selected (see section on “History ”). If the air pressure history is active, then the t...

21 Example for the display of minimum values. Display min/max values - The display mode is selected by touching the appropriate field “MAX” (field 27) or “MIN” (field 25). The particular touch screen field activated (MIN or MAX) will be faded out. Both titles are only visible in normal display mode....

22 3.4. Programming mode (entering alarm values) You can program the weather station so that an audible-visible alarm occurs when certain minimum or maximum values are reached. As well as this, daily wake-up times can be programmed so that the weather station can also be used as an alarm clock or an...

23 3.4.2. Setting/Resetting the MIN/MAX alarm values - After activating one of the alarm value displays (MIN or MAX), touch the value field for which the alarm value is to be set. - The value will flash and the lower control field will change to the following form: - The flashing value can be adjust...

24 3.4.4. Alarm initiation, Alarm reset - If the measured value exceeds or falls below one of the set alarm values, the display will go off and the alarm value in question together with the text “ALARM” and the appropriate high or low deviation (MAX or MIN) will be displayed. At the same time, an in...

26 Rotate the weather station a little if required, and if reception is bad, locate it away from electric motors, electrical machines, televisions, computer monitors and large metal surfaces. To facilitate commissioning you can initially locate the sensors in the vicinity of the base unit (at least ...

29 WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to th...