Kyocera KC-120-1 - Manuals

Kyocera KC-120-1 – Manual in PDF format online.

Manuals:

Manual Kyocera KC-120-1

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7

Summary

Page 2 - performance of the system and the safety of its users.; Figure 1. Module Tilt Angle; SITE

corrosion. ・ The solar module frame must be attached to a support structure using ¼” or M6 stainless steel hardware in a minimum of four (4) places symmetrical on the solar module. The stainless steel hardware used for securing themodule frame should secured with an applied torque of 6 foot-pounds (...

Page 3 - INSTALLING KC MODULES; The frame of each module has 0.28; Figure 3. Standard Wiring Examples

7. INSTALLING KC MODULES The frame of each module has 0.28 ” φ diameter (7 mm) mounting holes (Refer to Module Mounting Specifications). These are used to secure the modules to the supporting structure. An example of a ground mounted structure is shownin Figure 3. The four holes close to the corners...

Page 4 - Figure 4. Ring or Spade Terminal Connectors

C. The wire used to interconnect the solar modules may be single or two conductor, from 14 AWG (2.08mm 2 ) up to 10 AWG (5.26 mm 2 ) gauge stranded copper wire, in a “SUNLIGHT RESISTANT” jacketUF cable. This cable is suitable for applicationswhere wiring is exposed to the direct rays of thesun. The ...

Kyocera Manuals