Page 2 - TABLE OF CONTENTS
TABLE OF CONTENTS SECTION I INTRODUCTION Safety Precautions . . . . . . . . . . . . . . . . . . . . . . .1-2 SECTION II INSTALLATION Damage During Shipment . . . . . . . . . . . . . . . . . . .2Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2Positioning . . . . . . . . . . ....
Page 3 - WARNING; IMPORTANT
i POST THIS LABEL IN A PROMINENT LOCATION ON YOUR UNIT WARNING IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE ORMAINTENANCE CAN CAUSE PROPERTY DAMAGE, INJURY OR DEATH.READ THE INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONSTHOROUGHLY BEFORE INSTALLING OR SERVICING THIS EQUIPMENT. FOR YO...
Page 4 - I INTRODUCTION
I INTRODUCTION SAFETYPRECAUTIONS WARNING THIS SYMBOL WARNS YOU THAT SERIOUS BURNSOR OTHER INJURIES MAY RESULT IF SAFETYINSTRUCTIONS ARE NOT FOLLOWED. This service manual should be retained in a safeplace for future reference. The installation of yournew fryer must conform to local codes or in theabs...
Page 5 - Adequate air supply to the fryer.; II INSTALLATION; What to do if equipment arrives damaged:; INSTALLATION; ALL; connections and
2 Installed in accordance with all local codes, or inthe absence of local codes, with the currentNational Fuel Gas Code Z223.1/NFPA 54, NaturalGas Installation CAN/CGA-B149.1 or PropaneInstallation Code CAN/CGA-B149.2 Installed under a properly designed operatingexhaust hood. Connected to the type o...
Page 6 - Counter model and floor model fryers; must be; when installed in order; LEVELING; GAS CONNECTION
3 Counter model and floor model fryers must be restrained to prevent tipping when installed in order to avoid splashing, spilling, etc. of hot liquid. Therestraining method may be a manner of installation orby separate means. LEVELING The fryer will operate at its highest efficiency whenproperly lev...
Page 7 - III OPERATING; FILLING
4 A 3/4” NPT manual gas valve is factory installed witheach floor model fryer (for single fryers and batteries),except for 10x11AA – 20AA models which use a 1/2”NPT valve. The required gas pressure for properoperation of each fryer is 4” water column for naturalgas and 10” water column for Propane g...
Page 8 - LIGHTING
CAUTION: Oil expands when heated. The “Fill Level” line has been provided to ensure optimum cookingwhile ensuring the safety of the operator. Do not overfillthe fryer vessel. Figure 3-1 Fill Level Line A. AA and CMG Models 1. Fill the fryer vessel with oil or MELTED solid shortening up to the “Fill ...
Page 9 - MELTING; COOKING
6 7. Set the thermostat to the desired temperature (325°F - 335°F). MELTING The Keating Melt Cycle safely melts solid shortening inthe fryer vessel without scorching. WARNING BEFORE ATTEMPTING TO USE THE FRYER, MAKESURE THE FRYER HAS BEEN PROPERLY FILLEDWITH OIL. A. BB, TS and Basket-Lift Models 1. ...
Page 12 - DIGITAL TIMERS
WARNING WHEN YOUR FRYER IS BEING USED INCONJUNCTION WITH A CENTRAL FILTER, DISCONNECT POWER SUPPLY BEFORE RESETTING MOTOR TO PREVENT SERIOUSINJURY WHEN RESET SWITCH IS ENGAGED (SEEFILTER MANUAL). 16. Check thermostat bulb positioning – see page 10. 17. Refill the fryer with new or filtered oil. ELEC...
Page 13 - IV MAINTENANCE; WARRANTY; Locate thermometer in same position for every; SECTION; Yearly; PREVENTIVE MAINTENANCE CHART
10 output contacts will close. During the countdown the colonwill flash at a one-second rate. When the countdown hasreached "00:00" the relay output contacts will open, thedisplay will flash, and the audible alarm will sound. Tocancel the audible alarm, press any button. PAUSE FEATURE To pau...
Page 14 - C. Thermostat Bulb Positioning; Overshoot; V SERVICE DIAGNOSIS
C. Thermostat Bulb Positioning BEFORE REPLACING, TEST THERMOSTATS: These operational problems can easily becorrected by thermostat bulb positioning. Keating’s patented thermostat application is accurate within 2°F of the dial setting between250°F – 350°F. This accuracy is attained only if thethermos...
Page 17 - VI PARTS LISTS; ORDERING PARTS
14 VI PARTS LISTS ORDERING PARTS Parts may be ordered by part number by calling Keating at 1-800-KEATING or your local service company. Youmay also order on-line at Keating’s part store, www.keatingofchicago.comRefer to the Keating Instant Recovery® Gas fryer Limited Warranty for complete service an...
Page 18 - GAS FRYER ASSEMBLY
15 TS CONTROL PANEL AA/CMG CONTROL PANEL BB CONTROL PANEL GAS FRYER ASSEMBLY
Page 19 - RUNNER PILOT ASSEMBLY
16 RUNNER PILOT ASSEMBLY See Page 16 for part numbers.
Page 25 - VIII WIRING DIAGRAMS; AA
22 VIII WIRING DIAGRAMS NOTE: Separate wiring diagrams have been attached to the fryer and on the inside of this manual and should be saved for troubleshooting and maintenance. The wiring diagrams in this sectioncover standard fryers which may or may not match the diagrams sent with the fryer. Non-s...
Page 28 - ARRANTY
L IMITED W ARRANTY Keating Of Chicago, Inc. ("Keating”) warrants to the original purchaser . ("Customer"), all new Keating Fryers, Filter Systems, Griddles, Keep Krisp®, Custom Pasta Systems, Top-Side™ Cookers, Computer T imers, Fryer & Pasta V essels, and Keating replacement parts (...
Page 29 - KEATING LIMITED WARRANTY CARD; SERVICE INFORMATION; Have your serial and model number available when ordering parts.
KEATING LIMITED WARRANTY CARD PLEASE COMPLETE AND MAIL AT ONCE–WARRANTY IS NOT IN EFFECT UNTIL CARD IS RETURNED COMPANY: ______________________________________________________________________________________________________________ ADDRESS: ___________________________________________________________...