Kawasaki 840091 - Manuals

FUNCTIONAL DESCRIPTION CONTROLS AND COMPONENTS: 1. Column Base2. Column Assembly3. Column4. Column Rack5. Table Crank6. Table Support7. Table Crank Assembly8. Work Table9. Vise 10. Vise Clamp11. Knob (and mtg Hardware)12. Collar ASSEMBLY DO NOT connect the power cord to the AC receptacle until the d...

To minimize crank handle backlash, tighten the support lock, rotate the elevation worm shaft clockwise, assemble the crank tightlyagainst the table support and tighten setscrew. 11.Check column collar for proper adjustment. 12.Collar should not be aligned on the column. 13.Position rack so it will s...

INSTALLING THE HEAD ASSEMBLY The Head Assembly weighs approximately 55 pounds. Use caution when lifting it onto the column assembly. It is recommendedthat two people lift the head assembly onto the column. 1. Remove and discard the protective bag from head assembly. 2. Carefully lift head assembly a...

18 17 INSTALLING THE CENTER PULLEY The head assembly contains three pulleys. The firstpulley is on the is on the spindle shaft and the thirdpulley is on the motor shaft. The center pulley actsas an idler pulley making the installation andremoval of belts easier. This pulley plays an essential role i...

SQUARING THE WORKTABLE The combination square must be “true” when used to square the worktable. See Tools Required for Assembly. This is essential inorder to do precision drilling. 1. Insert a straight, ground steel rod, approxi- mately 3" long (not included) into the drillcheck and tighten. 2. ...

NEVER OPERATE LASER IF THE UNIT IS DEFECTIVE OR THE COVER OR SEALIS DAMAGED. DO NOT SERVICE LASER. The laser unit must be returned to the factory for any service or repair. Service or repair must be handled by authorized factorytrained technicians. Do not open the laser unit except to change batteri...

It is recommended that an approved ANSI full-face shield, that is impactresistant, be worn during all drill press operations. Should the full-faceshield not be available, approved ANSI safety glasses with impact resistantlenses and side shields MUST be used as a substitute. DO NOT use normalglasses....

9. Grasp the feed handles and rotate them toward the front of the drill press low- ering the drill bit onto the workpiece. This step is necessary to ensure the holewill be where it is intended. Make any adjustments necessary. 10.Plug the drill press power cord into the AC power source. Insert the YE...

SETTING THE DRILLING DEPTH ADJUSTMENT Turn the drill press ON/OFF switch to the OFF position and disconnect the AC power to prevent drill press from accidentally turning on. The drilling depth adjustment is used when more than one hole is to be drilled toexactly the same depth (i.e. drilling holes f...

found to be defective and subject to warranty. Alltrade retains the sole discretion to determine whether any item or part is nonconforming and, if so, whether the item and/or part will be repaired and/or replaced. If the unit is repaired, new orreconditioned replacement parts may be used. If Alltrad...