Kawasaki VULCAN 1700 VOYAGER - Manual
Kawasaki VULCAN 1700 VOYAGER – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation; Install CB Module; firmly but do not over tighten as this may damage the plastic; NOTE; If the optional XM Radio K10400-038 will also be installed,; Install CB Antenna; angle fitting on the CB module and firmly hand tighten.
- Page 4 – Install the antenna mast with star washer and confirm the; Do not use thread locking compound on the threads of the
- Page 5 – Please check/adjust all fasteners in regular intervals.; After confirming proper operation of the CB radio, reinstall the; Wipe the CB antenna clean with a soft damp cloth. Do not use
- Page 6 – Antenna Base Drilling Template
Installation Instructions
Assembly Instructions
Description:
CB Radio Kit
Model:
Vulcan 1700 Voyager
Part Number:
K10400-037
Approximate
Assembly Time:
60 min.
Installation of this accessory should be performed by a qualified technician with the proper tools and
equipment.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to
complete the installation. Please note that Kawasaki cannot assume any responsibility for damage
resulting from incorrect installation.
Parts List
Tools Required:
Seq.
Description
Qty
Tool Description
1.
CB Radio Module Assembly
1
Drill Motor
Scribe
1/16” Drill Bit
7mm (1/4”) Drill Bit
5mm Hex Head Driver
Socket Driver
10mm Socket
Philips Head Screwdriver
2.
M6 x 30mm Bolts
2
3.
CB Antenna Cable
1
4.
CB Antenna Base
1
5.
M6 x 20mm Philips Head Bolt
1
6.
CB Ground Strap
1
7.
M6 Lock Nuts
2
8.
Lock Washer
1
9.
Belleville Washer
1
10.
M6 Cap Nut
1
11.
Cable Ties, 6 inch
8
12.
Cable Tie, 14.5 inch
1
13.
CB Antenna Mast
1
14.
Star Washer
1
Installation Preparation
Parts Removal
z
Set bike securely on side stand on level ground. Switch off
ignition and remove key.
z
Refer to the VN1700 Voyager Service Manual and remove the
fairing. Remove the front and rear seats, fairing and left fairing
lower cover (black piece).
z
Open the trunk and remove the tray by pressing the center of
the four lock rivets.
z
Remove the fuel tank mounting bolts and lift the tank to expose
the frame.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installation Install CB Module z Mount the CB module using the two supplied 6 x 30mm bolts on the top and re-using the lower bolt. Tighten all three bolts firmly but do not over tighten as this may damage the plastic fairing lower. z Route the harness from the CB module behind the left engine guard ...
z Install the antenna base from the outside of the trunk. Install Belleville (curved) washer and locknut onto the threaded brass post. Do not over-tighten as this may damage the plastic base. z Remove the right rear trunk bolt and install the provided metal grounding bracket at this point and to the...
Please check/adjust all fasteners in regular intervals. © Kawasaki Motors Corp., U.S.A., August 2009 z After confirming proper operation of the CB radio, reinstall the fairing, left fairing lower, lower cover, front and rear seats, and tank. Check carefully to be sure that the wires are not caught o...
