Johnson Controls 13 SEER - Manuals

Page 2 - Johnson Controls Unitary Products; SECTION III: UNIT INSTALLATION; LOCATION; For multiple unit installations, units must be spaced a minimum; GROUND INSTALLATION; as marked on the original factory drier. See; Apply with Models; All Models

347337-UIM-A-0408 2 Johnson Controls Unitary Products SECTION III: UNIT INSTALLATION LOCATION Before starting the installation, select and check the suitability of thelocation for both the indoor and outdoor unit. Observe all limitations andclearance requirements. The outdoor unit must have sufficie...

Page 3 - Using a larger than specified line size could result in oil return; OIL TRAPPING; Oil Trap; INDOOR; Installation of Vapor Line; TO OUTDOOR UNIT

347337-UIM-A-0408 Johnson Controls Unitary Products 3 PIPING CONNECTIONS The outdoor condensing unit must be connected to the indoor evapora-tor coil using field supplied refrigerant grade (ACR) copper tubing that isinternally clean and dry. Units should be installed only with the tubingsizes for ap...

Page 4 - Connect the refrigerant lines using the following procedure:; SECTION IV: ORIFICE INSTALLATION; Install Schrader Valve Core as follows:

347337-UIM-A-0408 4 Johnson Controls Unitary Products Connect the refrigerant lines using the following procedure: 1. Remove the cap and Schrader core from both the liquid and vaporservice valve service ports at the outdoor unit. Connect low pres-sure nitrogen to the liquid line service port. 2. Bra...

Page 5 - SECTION V: INSTALLATIONS REQUIRING; SUBCOOLING CHARGING METHOD - MIXED MATCH; Do not leave the system open to the atmosphere.

347337-UIM-A-0408 Johnson Controls Unitary Products 5 SECTION V: INSTALLATIONS REQUIRING AN ADD-ON TXV KIT For installations requiring a TXV kit, refer to the Installation Instructionsaccompanying the TXV kit. SECTION VI: EVACUATION It will be necessary to evacuate the system to 500 microns or less....

Page 6 - SECTION VIII: ELECTRICAL; GENERAL INFORMATION & GROUNDING

347337-UIM-A-0408 6 Johnson Controls Unitary Products SECTION VIII: ELECTRICAL CONNECTIONS GENERAL INFORMATION & GROUNDING Check the electrical supply to be sure that it meets the values specifiedon the unit nameplate and wiring label. Power wiring, control (low voltage) wiring, disconnect switc...

Page 7 - Single Stage Air Conditioner

347337-UIM-A-0408 Johnson Controls Unitary Products 7 For additional connection diagrams for all UPG equipment refer to “Low Voltage System Wiring” document available online at www.upgnet.com in theProduct Catalog Section. FIGURE 9: Thermostat Chart - Single Stage AC with PSC Air Handler AC 1A Singl...

Page 11 - Cooling; The vapor line at the outdoor unit will feel cool to the touch.; Instructing the Owner

347337-UIM-A-0408 Johnson Controls Unitary Products 11 INDICATIONS OF PROPER OPERATION Cooling 1. The outdoor fan should be running, with warm air being dis-charged from the top of the unit. 2. The indoor blower (furnace or air handler) will be operating, dis-charging cool air from the ducts. Coils ...

Page 12 - Copyright; NOTES

Subject to change without notice. Printed in U.S.A. 347337-UIM-A-0408 Copyright © 2008 by Johnson Controls, Inc. All rights reserved. Supersedes: 259715-UIM-A-0606 Johnson Controls Unitary Products 5005 York Drive Norman, OK 7306 NOTES