Impex MCB-347 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS; BEFORE YOU BEGIN; INC. For your safety and benefit, read this manual carefully; please call our TOLL-FREE customer service; Our Customer Service Agents will provide immediate assistance

TABLE OF CONTENTS BEFORE YOU BEGIN............................................................................................... 1 IMPORTANT SAFETY NOTICE................................................................................ 2 HARDWARE PACK……..................................................

Page 3 - IMPORTANT SAFETY NOTICE; PRECAUTIONS; CARE AND MAINTENANCE; Toll-Free Customer Service Number

1 IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety prec...

Page 5 - WARNING LABEL REPLACEMENT

WARNING LABEL REPLACEMENT The Warning Label shown here has been placed on the Cross Brace. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown. 3

Page 6 - HARDWARE PACK

Page 7 - ASSEMBLY INSTRUCTION; machine to avoid possible injury.; STEP 1; DIAGRAM 1

ASSEMBLY INSTRUCTION Tools required assembling the machine: Two Adjustable Wrenches and Allen Wrenches. NOTE: It is strongly recommended two or more people assembling this machine to avoid possible injury. STEP 1 (SEE DIAGRAM 1) A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#2) in th...

Page 8 - STEP 2; DIAGRAM 2

STEP 2 (SEE DIAGRAM 2) A.) Attach the Front Stabilizer (#5) to the Main Seat Support (#3). Secure it with two M10 x ¾” Hex Bolts (#43), four ∅ ¾” Washers (#48), and two M10 Aircraft Nuts (#51). DO NOT tighten the nuts and bolts yet. B.) Attach the Main Seat Support (#3) to the Cross Brace (#2). Secu...

Page 9 - DIAGRAM 3

STEP 3 (SEE DIAGRAM 3) A.) Attach the Leg Developer (#6) to the bracket on the Front Stabilizer (#5). Secure it with one M10 x 2 ¾” Hex Bolt (#42), two Ø ¾” Washers (#48), and one M10 Aircraft Nut (#51). Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel. B.) Insert ...

Page 10 - STEP 4; DIAGRAM 4

STEP 4 (SEE DIAGRAM 4) A.) Attach the side holes on the Backrest Supports (#14) to the Pivot on the Main Seat Support (#3). Place the other end rest against the Backrest Adjustment Bar (#9). B.) Attach the Backrest Board (#19) onto the Backrest Supports. Secure it with four M6 x 1 ½” Hex Bolts (#47)...

Page 11 - STEP 5

8 STEP 5 (SEE Diagram 5) A.) Attach the ball end of the Cable (#38) to the Pulley (#36). Place the Pulley in the open slot on the Lat Bar Frame (#15). Secure the Pulley with one M10 x 2 1/8” Hex Bolt (#41), two Bushings (#37), and one M10 Aircraft Nut (#51). B.) Slide the Weight Holder (#13) onto th...

Page 15 - LIMITED WARRANTY; IMPEX

IMPEX ® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX ® ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty extends only to the original purchaser. IM...