Impex MCB-346 - Manuals - manualsarea.com

Page 2 - TABLE OF CONTENTS; BEFORE YOU BEGIN; INC. For your safety and benefit, read this manual carefully; please call our TOLL-FREE customer service; Our Customer Service Agents will provide immediate; Toll-Free Customer Service Number

TABLE OF CONTENTS BEFORE YOU BEGIN...............................................................................................1 IMPORTANT SAFETY NOTICE................................................................................2 HARDW ARE PACK……...................................................

Page 3 - IMPORTANT SAFETY NOTICE; PRECAUTIONS

IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precau...

Page 4 - WARNING LABEL REPLACEMENT

WARNING LABEL REPLACEMENT The Warning Label shown here has been placed on the Cross Brace. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown. 3

Page 5 - HARDWARE PACK

Page 6 - ASSEMBLY INSTRUCTION; STEP 1; DIAGRAM 1

ASSEMBLY INSTRUCTION Tools required assembling the machine: Two Adjustable Wrenches and Allen Wrenches STEP 1 (SEE Diagram 1) A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#15) in the Mid-span. Secure them with two M10 x 2 3/8” Hex Bolts (#2), four ∅ ¾” Washers (#3), one Bracket (#7)...

Page 7 - STEP 2

STEP 2 (SEE DIAGRAM 2) A.) Connect the Front Stabilizer (#42) to the Main Seat Support (#52) and secure them with two M10 x ¾” Hex Bolts (#46), four ∅ ¾” Washers (#3), and two M10 Aircraft Nuts (#4). DO NOT tighten the nuts and bolts yet. B.) Connect the Main Seat Support (#52) to the open bracket o...

Page 8 - DIAGRAM 3

STEP 3 (SEE DIAGRAM 3) A.) Attach the Leg Developer (#38) to the bracket on the Front Stabilizer (#42). Secure it with a Socket axle (#44) and Socket Screw (#45). Do not over tighten the Screw. Make sure the Leg Developer is able to swivel. B.) Insert two Foam Roll Tubes (#39) halfway through the ho...

Page 9 - STEP 4; DIAGRAM 4

STEP 4 (SEE DIAGRAM 4) A.) Attach the Backrest Supports (#16) onto both ends of the Pivot on the Main Seat Support (#52). Place the other end rest against the Backrest Adjustment Bar (#10). B.) Place the Backrest Board (#18) onto the Backrest Supports. Secure it with four M6 x 1 3/8” Hex Bolts (#50)...

Page 10 - STEP 5

STEP 5 (SEE Diagram 5) A.) Attach the ball end of the Cable to the Pulley (#28). Place the Pulley in the open slot on the Lat Bar Frame (#31). Secure it with one M10 x 2 1/8” Hex Bolt (#32), two Bushings (#29), two ∅ ¾” Washers (#3), and one M10 Aircraft Nut (#4). B.) Slide the Weight Holder (#33) o...

Page 13 - LIMITED WARRANTY; IMPEX

IMPEX ® INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX ® ") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty extends only to the original purchaser. IM...