Hisense WFGE801439VMQ - Manuals

864036 7 CHILD SAFETY Before closing the washing machine door and running the programme, make sure there is nothing except laundry in the drum (e.g. if a child climbed into the washing machine drum and closed the door from the inside). Keep the detergent and conditioner out of reach of children. Act...

864036 8 BACK 1 Water supply hose 2 Power cord 3 Water discharge hose 4 Adjustable feet FRONT 1 Control unit 2 Start/pause button 3 Programme selector knob 4 On/off button 5 Dispenser tray 6 Door7 Rating plate 8 Pump filter 3 4 2 5 6 8 7 1 WASHING MACHINE DESCRIPTION 2 1 3 4 864036en.indd 8 864036en...

864036 9 Rating plate TECHNICAL SPECIFICATIONS (DEPENDING ON THE MODEL) Rating plate with basic information about the washing machine is fitted on the front wall of the washing machine door opening (see chapter »WASHING MACHINE DESCRIPTION«). Maximum load See rating plate Width 600 mm 600 mm 600 mm ...

864036 10 2 PROGRAMME SELECTOR KNOB 3 START/PAUSE BUTTON Use this button to start or pause a programme. Upon start-up or during pause, the button backlight will flash; when the programme is started and in progress, it will be lit continuously. 1 ON/OFF BUTTON Use this button to turn the washing mach...

864036 12 1 Move the hoses and undo the screws on the back of the washing machine.Remove the two angular pieces. 2 Slide the angular pieces onto the grove in the blocking rod; before doing so, rotate the right angular piece to the opposite side. 3 Use the angular pieces to rotate the blocking rods b...

864036 13 MOVING AND TRANSPORT AFTER INSTALLATION If you wish to move the washing machine after it has been installed, the angular pieces and at least one blocking rods have to be re-installed to prevent vibration damage to the washing machine during transport (see chapter »INSTALLATION AND CONNECTI...

864036 14 Incorrect levelling of the washing machine with the adjustable legs may cause vibration, appliance sliding across the room, and loud operation. Incorrect levelling of the washing machine is not subject to warranty. Sometimes, unusual or louder noise may appear during appliance operation; t...

864036 15 Opening the washing machine door (bird's-eye view) b a 180° See chapter »WASHING MACHINE DESCRIPTION/Technical information«). a = Washing machine depthb = Depth with door open The washing machine may not be in contact with a wall or adjacent furniture. For optimum washing machine operation...

864036 16 For normal washing machine operation, the pressure in the water mains should be between 0.05 and 0.8 MPa (0,5 - 8 bar). Minimum dynamic water pressure can be determined by measuring the water flow. In 30 seconds, 1.2 litres of water should flow from a fully open tap. Tighten the water supp...

864036 18 2 h Before connecting the washing machine to the power mains, wait for at least 2 hours until it reaches room temperature. Connect the washing machine to a grounded power outlet. After installation, the wall outlet should be freely accessible. The outlet should be fitted with an earth cont...

864036 20 WASHING PROCESS, STEP BY STEP (1–6) STEP 1: HEED THE LABELS ON THE LAUNDRY Normal wash;Sensitive laundry Max. washing temp. 95°C 95 95 Max. washing temp. 60°C 60 60 Max. washing temp. 40°C 40 40 Max. washing temp. 30°C 30 30 Hand wash only Do not wash Bleaching Bleaching in cool water c1 B...

864036 22 LOADING THE WASHING MACHINE Open the washing machine door by pulling the handle towards you (figure 1).Insert the laundry into the drum (after making sure the drum is empty) (figure 2).Make sure that no garment is stuck between the door and the rubber gasket. Close the washing machine door...

864036 23 During operation, the programme selector knob (2) will not rotate automatically. Washing programmes are comprehensive programmes that include all washing stages, including softening and spinning (this does not apply to Partial programmes). Partial programmes are independent programmes. Use...

864036 24 PROGRAMME TABLE Programme Max. load Maximum spinning rate Programme description Cotton White 40°C - 90°C * MAX MAX 1) Programme for washing white and coloured cotton laundry, towels, bed linen, T-shirts etc.The temperature can be set separately; therefore, observe the instructions indicate...

864036 28 STEP 4: SELECTING ADDITIONAL FUNCTIONS Most programmes feature basic settings, but these settings can be changed. Adjust the settings by pressing the relevant function button (before pressing the (3) START/PAUSE button). Functions that cannot be changed with the selected washing programme ...

864036 30 Some settings cannot be selected with certain programmes. Such functions will not be lit on the display unit, and when the corresponding button is pressed, an acoustic signal will be emitted and the light on the button will flash (see FUNCTION TABLE). Activate/deactivate the functions by p...

864036 31 When the washing machine is switched off, all extra functions return to their basic or custom settings, except for the acoustic signal setting. CHILD LOCK A safety feature. To activate the child lock, simultaneously press the (5) SPIN (SPINNING RATE/DRAIN/PUMP STOP) and (7) WASHING TEMPERA...

864036 32 FUNCTION TABLE Programmes FAST SUPER FAST DELAY END STEAM WATER+ SPIN (SETTING THE SPINNING RATE) PUMP STOP Cotton White 40°C - 90°C • • • • • • • Colour 20°C - 90°C • • • • • • Mix(Mixed laundry/Synthetics) 20°C - 60°C • • • • • • Wool 20°C - 40°C • • • • • • Eco 40-60 Power Wash 59´/32´ ...

864036 35 • water temperature in the drum has to be suitable, • water level in the drum has to be below a certain value. In order to add or remove laundry from the washing machine during programme operation, proceed as follows:1. Press the (3) START/ PAUSE button. 2. If all conditions for release of...

864036 36 Do not wash the dispenser tray in a dishwasher. MAINTENANCE & CLEANING Before cleaning, unplug the washing machine from the power mains. Children should not clean the washing machine or perform maintenance tasks without proper supervision! CLEANING THE DISPENSER TRAY The dispenser tray...

864036 38 The pump filter must be occasionally cleaned, especially after washing very fleecy, woolly, or very old laundry. CLEANING THE PUMP FILTER During cleaning, some water may be spilled. It is therefore recommended to place an absorbent cloth on the floor. 1 Open the pump filter cap using a sui...

864036 39 CLEANING THE WASHING MACHINE EXTERIOR Always disconnect the washing machine from the power mains before cleaning. Clean the washing machine exterior and display unit using a soft damp cotton cloth and water. Do not use any solvents or cleaning agents that could damage the washing machine (...

864036 40 TROUBLESHOOTING WHAT TO DO ...? The washing machine shall automatically control the operation of particular functions during the washing cycle. If any irregularity is identified, this will be indicated by reporting (E:XX) on the display. The washing machine will report the error until it i...

864036 45 In case of a defect, only use approved spare parts by authorized manufacturers. Repair or any warranty claim resulting from incorrect connection or use of the washing machine shall not be covered by the warranty. In such cases, the costs of repair shall be charged to the user. The warranty...

864036 49 PRODUCT INFORMATION PRODUCT INFORMATION SHEET According to EU-Regulation No. 2019/2014 (depending on the model) Supplier’s name or trade mark: Supplier’s adress ( b ): Model identifier: General product parameters: Parameter Value Parameter Value Rated capacity ( a ) (kg) x,x Dimensions in ...

864036 50 Minimum duration of the guarantee offered by the supplier ( b ): This product has been designed to release silver ions during the washing cycle [YES/NO] Additional information: Weblink to the supplier's website, where the information from point 9 Anex II to Commition Regulation (EU) 2019/2...

864036 51 We reserve the right to any changes and errors in the instructions for use. Packaging is made of environmentally friendly materials that can be recycled, disposed of, or destroyed without any hazard to the environment. To this end, packaging materials are labelled appropriately. The symbol...