Hayter 447F - Manuals

Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer’s Mark 1. Indicates the blade is identified as a part from the originalmachine manufacturer. 110-7058 1. Height of cut 110-7059 Model 447F only 1....

Setup Unfolding the Handle 1. Unlock the handle locks, move the handle sections into the operating position, and lock the handle locks(Figure 3). Figure 3 2. Unlock the upper handle locks and rotate the upper handle upward and lock it into a position that iscomfortable to you (Figure 4). Figure 4 1....

Installing the Fuse (Model447F Only) Your mower comes with a 40-amp fuse that protects theelectric starter. Important: You cannot start the mower with the electric starter or charge the battery unless youinstall the fuse. 1. Remove the battery cover and the battery and locate the fuse holder (Figure...

Product Overview G01201 1 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Figure 9 Model 447F shown 1. Lower handle lock 8. Rear door 2. Grass bag 9. Oil fill/Dipstick (not shown) 3. Upper handle lock 10. Fuel tank cap 4. Recoil start handle 11. Cutting height lever (2) 5. Upper handle 12. Spark plug 6. Blade cont...

detergent oil with an API service classification ofSF, SG, SH, SJ, SL, or higher.) 3. Install the dipstick. Adjusting the Cutting Height Adjusting the cutting height may bring you intocontact with the moving blade, causing seriousinjury. • Stop the engine and wait for all moving partsto stop. • Do n...

sides, and the mower will automatically keep pace withyou. Figure 15 Stopping the Engine 1. Release the blade control bar (Figure 16). Figure 16 2. When the engine stops, remove the ignition key when you leave the mower. Important: When you release the blade control bar, both the engine and blade sh...

G008083 Figure 18 Removing the Grass Bag To remove the bag, reverse the steps above. Rear-discharging theClippings Use the rear discharge for cutting very tall grass. If the bag is on the mower, remove it (refer to Removingthe Grass Bag) before rear-discharging the clippings(Figure 19). The Recyclin...

– Raise the cutting height on your mower. – Cut the grass more frequently. – Overlap cutting swaths instead of cutting a full swath with each pass. – Set the cutting height on the front wheels one notch lower than the rear wheels. For example,set the front wheels at 60 mm and the rearwheels at 70 mm...

Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure After the first 5 hours • Change the engine oil. Before each use or daily • Check the engine oil level.• Ensure that the engine stops within 3 seconds after releasing the blade control bar.• Clean the ...

Lubrication Lubricating the Wheel Gears Service Interval: Yearly—Lubricate the wheel gears. 1. Remove the wheel bolts on the rear wheels and remove the rear wheels. 2. Apply a lubricating oil to the gear as shown in Figure 21. Figure 21 3. Install the rear wheels. Engine Maintenance Replacing the Ai...

Drive SystemMaintenance Adjusting the Self-propel Drive If your mower does not self-propel properly, adjust theself-propel drive cable. 1. Loosen the nut on the cable mount (Figure 25). Figure 25 1. Nut on cable mount 2. Pull the upper handle back fully rearward (Figure 26). Figure 26 3. Pull the ca...

Blade Maintenance Replacing the Blade Service Interval: Every 25 hours—Replace the bladeor have it sharpened (more frequentlyif the edge dulls quickly). Important: You will need a torque wrench to install the blade properly . If you do not have a torque wrench or are uncomfortable performing thispro...

Cleaning Cleaning the Mower Service Interval: Before each use or daily—Clean the mower. Tipping the mower may cause the fuel to leakfrom the carburetor or the fuel tank. Petrolis extremely flammable, highly explosive, andunder certain condition can cause personalinjury or property damage. Run the en...

CUS TOME R INFO RMATION Date of Sale:-Your Local Dealer:- HAYTER L IMITED, SPELLBROOK, BISHOP’S STORTFORD, HERTS. CM23 4BU, ENGLAND Code Serial No.